User Guide

LAN Device Commands Supported Commands

ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)

There is no Set Selector or Block Selector with this command.

2.1.7.1.4 System Boot Options #99

This parameter is an Emerson-specific OEM parameter. It is used to enable or disable BIOS

and FRU write protection

There is no Set Selector or Block Selector with this command. The Boot Option parameter data

returned with the IPMI command Get System Boot Options provides the write protect status of

the two BIOS flashes and of the FRU information (one byte for each instance).

2.1.8 LAN Device Commands

The System Boot Options parameter #98 is non-volatile. Its parameter data remains

preserved after IPMC power cycles and firmware upgrades.

Table 2-12 System Boot Options Parameter #99

Boot Option Parameter

Data Description

1 This parameter enables/disables BIOS and FRU write protection:

[7:4] Bios ID (0= Boot Bank A, 1= Boot Bank B, 2= FRU information,

others reserved)

[3:0] write protect enable/disable (0= disable, 1= enable, others reserved)

Table 2-13 Supported LAN Device Commands

Command NetFn (Request/Response) CMD

Set LAN Configuration Parameters 0x0C/0x0D 0x01

Get LAN Configuration Parameters 0x0C/0x0D 0x02

Set SOL Configuration Parameters 0x0C/0x0D 0x21

Get SOL Configuration Parameters 0x0C/0x0D 0x22