BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 1 READ AND SAVE THESE INSTRUCTIONS ATOMICAL™ 52” Damp Location Ceiling Fan Owner's Manual Model No. CF930BS02 CF930ORB02 CF930WW02 Net Weight: Part No. F40BP73320002 18.0 Lbs. Form No. BP7332-2 UL Model No.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM ! Page 2 WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 3 THIS FAN IS SUITABLE FOR DAMP LOCATIONS SUCH AS COVERED PORCHES, COVERED PATIOS, AND COVERED DECKS...ANYWHERE THERE IS A ROOF OVERHEAD. This Manual is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Tools Needed for Assembly Installed Wire Length Up to 50 ft. 50-100 ft.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 4 A. FAN MOTOR ASSEMBLY B. COUPLING COVER C. CEILING COVER D. FAN BLADES F. LIGHT KIT ASSEMBLY E. LOWER HOUSING K. 60-WATT CANDELABRA BULBS G. HANGER BRACKET H. HANGER BALL/ 4.5" DOWNROD ASSEMBLY I. LOWER GLASS J. FAN/LIGHT REMOTE CONTROL L. LOOSE PARTS BAG NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. PROTECTIVE PLASTIC BAG 2.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 5 Electrical Requirements Ceiling Fan Procedures IMPORTANT: Your ceiling fan will not function properly, and may be damaged, if used with any wall dimmer switch or control other than the Emerson Electric Fan/Light Wall Control supplied with the fan, or an optional Emerson Electric SR100 Remote Control.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM 2. Loosen setscrew in motor coupling if necessary. Separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 2). The clevis pin must go through the holes in the motor coupling and the holes in the downrod.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 7 5. Reinstall the hanger ball (Figure 4) on the downrod as follows. Route the motor leads through the downrod. Position the pin through the two holes in the downrod and align the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 8 How to Hang Your Ceiling Fan NOTE: Make sure wires are not pinched between fan motor assembly and lower housing. 10. Connect the black wire of the light kit assembly to the blue wire of the fan motor assembly using one wire connector (supplied). Connect the white wire of the light kit assembly to the white wire of the fan motor assembly using a supplied wire connector (Figure 8).
BP7332-2 CF930 Atomical ! 9/23/10 3:29 PM Page 9 How to Wire Your Ceiling Fan WARNING Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall. If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 10 e. Securely connect the fan motor black wire to the receiver red (TO MOTOR L). Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result. f. Securely connect the fan motor blue wire to the receiver blue (FOR LIGHT) wire.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 11 6. Screw in two 60-watt (maximum) candelabra base bulbs (supplied) in the light kit assembly sockets (Figure 3. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 13). 4. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 15). LIGHT KIT ASSEMBLY SOCKET (2) 5.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Remote Control Procedures Page 12 Installation of Battery 1. Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 18). General Your Emerson Ceiling Fan/Light Remote Control consists of hand-held transmitter and a receiver which is mounted under the fan ceiling cover. The remote control is designed to separately control your ceiling fan speed and light intensity. There are four push buttons (., .., ..., ....
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 13 Installation of Storage Bracket COVER A storage bracket is provided for holding your remote control when not in use (Figure 19). If you desire to use the bracket, install it on a wall that is away from excess heat or humidity.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Maintenance Trouble Shooting Remote Control IMPORTANT CARE INSTRUCTIONS for your Ceiling Fan Fan/Light Fails to Operate • Check that the speed switch on the fan is set to HIGH (....) speed. • Check that the light switch is on. • Check that the battery is good (red indicator light should light when any button is pressed). • Check that the receiver is wired properly. • Check that code switches in the remote control and receiver are set in the same position.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 15 WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX ! OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting Ceiling Fan TROUBLE 1. Fan will not start. PROBABLE CAUSE 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan. 3. Code switches in remote control receiver and Fan/Light Wall Control are not set in the same position. SUGGESTED REMEDY 1. Check main and branch circuit fuses or circuit breakers.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 16 Repair Parts 2 1 6 8 3 7 13 14 9 10 21 15 22 5 17 4 20 11 16 18 12 12 19 Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REPAIR PARTS WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: • PART NUMBER • PART DESCRIPTION • NAME OF ITEM • MODEL NUMBER The model number of your Fan will be found on a label attached to the top housing. For repair parts, phone 1-800-654-3545. 16 UL Model No.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 17 Repair Parts Listing Part Numbers Key No. Description Model No. CF930BS02 Model No. CF930ORB02 Model No. CF930WW02 * 1 2 3 Hanger Pack, Consisting of: Hanger Bracket Assembly (1) Hanger Ball (1) Downrod (1) 761655-17 — — — 761655-32 — — — 761655 — — — * 4 5 6 7 8 763280 — — — — 763280 — — — — 763280 — — — — — — — — — — — — — — — — 13 Parts Bag, Containing: Pin, Clevis (1) Clip, Hairpin (1) Connector, Wire, 12 Ga.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 18 INSTRUCTION TO THE USER (if device contains a digital device) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 19 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson Electric Co. ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for the lifetime of your ceiling fan.
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 20 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Part No. F40BP73320002 Printed in China 09/10 Form No. BP7332-2 UL Model No.
