Technical data

Guide Specifications for Liebert Mini-Mate2- 5-Ton Systems
Liebert
®
Mini-Mate2
™
37
GUIDE SPECIFICATIONS FOR LIEBERT MINI-MATE2- 5-TON SYSTEMS
1.0 General
1.1 Summary
These specifications describe requirements for an environmental control system. The system shall be
designed to control temperature and relative humidity conditions within the room.
The manufacturer shall design and furnish all equipment in the quantities and configurations shown
on the project drawings.
System shall be supplied with CSA Certification to the harmonized U.S. and Canadian product safety
standard CSA C22.2 No 236/UL 1995 for “Heating and Cooling Equipment” and marked with the CSA
c-us logo (60 Hz only).
The system model number(s) shall be_________________________________________________________.
1.2 Design Requirements
The environmental control system shall be a Liebert Mini-Mate2 factory-assembled unit. On direct
expansion models, the refrigeration system shall be split, with the compressor located in a remote or
close-coupled condensing unit.
The evaporator section shall be designed for above dropped-ceiling installation. Condensing units
shall be designed for either outdoor or above-dropped-ceiling installation.
The system shall have a total cooling capacity of _______ BTU/hr (kW) and a sensible cooling capacity
of ________ BTU/hr (kW), based on the entering air condition of _____°F (°C) dry bulb and _____°F (°C)
wet bulb.
The unit is to be supplied for operation on a ______ volt, ______ phase, ______ Hz power supply.
1.3 Submittals
Submittals shall be provided with the proposal and shall include: Dimensional, Electrical and
Capacity data; and Piping and Electrical Connection Drawings.
1.4 Quality Assurance
The specified system shall be factory-tested before shipment. Testing shall include, but shall not be
limited to: Quality Control Checks, “Hi-Pot” Test (two times rated voltage plus 1000 volts, per NRTL
agency requirements), and Metering Calibration Tests. The system shall be designed and
manufactured according to world-class quality standards. The manufacturer shall be ISO 9001
certified.