User`s manual

System Management: Vendor Commands
10009109-01 ATCA-9305 User’s Manual
7-31
Get Handle Switch
The Get Handle Switch command reads the state of the Hot Swap handle of the IPMC. Over-
riding of the handle switch state is allowed only if the IPMC operates in (Manual) Standalone
mode.
Table 7-24: Get Handle Switch Command
Set Handle Switch
The Set Handle Switch command sets the state of the Hot Swap handle switch in (Manual)
Standalone mode.
Table 7-25: Set Handle Switch Command
4 Hardware Address
If set to 00, the ability to override the hardware address is
disabled
NOTE: A hardware address change only takes effect after an
IPMC reset. See “Reset IPMC” on page 7-33.
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5 Handle Switch Status
0x00 The handle switch is open
0x01 The handle switch is closed
0x02 The handle switch state is read from hardware
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4 Handle Switch Status
0x00 The handle switch is open
0x01 The handle switch is closed
0x02 The handle switch state is read from hardware
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field: (continued)