BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 1 READ AND SAVE THESE INSTRUCTIONS 44”, 54”, or 60” Fan Blades Not Included (B79 Not Recommended) PENBROOKE SELECT™ Ceiling Fan Owner's Manual Model Numbers CF5100BS00 - Brushed Steel CF5100GES00 - Golden Espresso CF5100ORB00 - Oil Rubbed Bronze CF5100SW00 - Satin White CF5100VNB00 - Venetian Bronze CF5100VS00 - Vintage Steel Net Weight: 20.2 Lbs.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 2 Table of Contents Section Page 8. Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 9. Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 10. Accent Light Harness Installation . . . . . . . . . . . . . . . . .13 11. Optional AL100 Accent Light Installation . . . . . . . . . . .14 12. Trouble Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15 13. Repair Parts . . .
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 3 1. Unpacking Instructions PACKAGE CONTENTS WARNING ! Do not install or use fan if any part is damaged or missing. Call Toll-Free: Part 1-800-654-3545 WARNING ! This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 4 1. Unpacking Instructions (continued) This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Up to 50 ft. 50-100 ft. Tools Needed for Assembly One Phillips head screwdriver One 1/4” blade screwdriver One stepladder One wire stripper ! Materials Wire Size A.W.G.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 5 3. Ceiling Fan Assembly 3.1 #10-24 x 12mm ROUND HEAD BLADE SCREW (4) Mount the fan blade (sold separately) using the four #10-24 x 12mm round head screws and flat washers (supplied) to secure flange to blade (Figure 1). 9/16" FLAT WASHER (4 per blade/flange) Repeat for the remaining four blades. FAN BLADE (sold separately) NOTE: Some accessory blades are supplied with shorter screws.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 6 3. Ceiling Fan Assembly (continued) Installation of Switch Cup Assembly for Manual Control PULL CHAIN SWITCH 3.4 Engage the connector of the switch cup assembly with the motor connector (Figure 4). The two connectors are keyed and color-coded and must be mated correctly (color-to-color) before they can be engaged. Make sure the connector latch closes properly.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 7 3. Ceiling Fan Assembly (continued) 3.7 PIN Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 7). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 3.13. HANGER BALL SETSCREW DOWNROD Figure 7 3.8 Loosen setscrew in motor coupling if necessary. Separate, untwist and unkink the three 80” motor leads.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 8 3. Ceiling Fan Assembly (continued) 3.10 #8-32 x 1-1/4" THREADED STUD (2) Screw two #8-32 x 1-1/4” threaded studs (provided) into the motor (Figure 10). Leave approximately 7/8” of the stud extending above the motor. 7/8" MOTOR Figure 10 3.11 NOTE: Make sure the red and brown leads are capped with wire connectors.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 9 4. How to Hang Your Ceiling Fan ! CEILING WARNING The fan must be hung with at least 7' of clearance from floor to blades (Figure 13). AT LEAST 7' Figure 13 ! FLOOR WARNING The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support of 22.7 kg. (50 lbs.) or less”.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 10 4. How to Hang Your Ceiling Fan (continued) 4.3 NOTE: CEILING COVER, SUPPLY WIRES AND FAN WIRES OMITTED FOR CLARITY. Carefully lift the fan and seat the hanger ball/ downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 16). Be sure the groove in the ball is lined up with tab on the hanger bracket (Figure 15).
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 11 6. Final Assembly 6.1 Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 18). 6.2 CEILING COVER Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 18).
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 12 8. Maintenance IMPORTANT CARE INSTRUCTIONS for your Ceiling Fan ! WARNING Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock. Periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 13 10. Accent Light Harness Installation 10.1 COUPLER COVER NOTE: If you are planning to install an optional Emerson Accent Light Fixture on your ceiling fan, remove the coupler cover at this time for installation. DO NOT REMOVE THESE WIRE CONNECTORS BROWN WIRE Locate the yellow wire terminated by a wire connector on top the motor housing assembly (Figure 20). RED WIRE DOWNROD MOTOR COUPLING YELLOW WIRE CONNECTOR FROM MOTOR Figure 20 10.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 14 11. Optional AL100 Accent Light Installation 11.1 AL100 ACCENT LIGHT HARNESS SCREW (3) CAUTION: To reduce the risk of electric shock, disconnect the electrical supply circuit to the fan before installing light kit assembly. AL100 ACCENT LIGHT HARNESS Position the AL100 accent light so that the opening of the AL100 accent light slides through the downrod. Align the mounting holes of the AL100 accent light to the motor assembly (Figure 22).
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 15 12. Trouble Shooting ! WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. TROUBLE 1. Fan will not start. PROBABLE CAUSE SUGGESTED REMEDY 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. 2. Loose power line connections to the fan, or loose switch wire connections in the 2.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 16 13. Repair Parts 7 4 1 8 12 6 13 9 5 2 16 3 17 14 19 10 18 15 6 8 7 7 8 11 20 6 11 32 12 28 (NOT SUPPLIED) 27 9 5 4 13 26 21 22 31 23 22 30 17 16 24 25 10 10 29 10 Before discarding packaging material, be certain all parts have been removed.
764411-GES 764412-GES 764422 763493 760601 764420 762508 762508 764415-GES * 764417-GES 764418-GES 764419-GES 761790 BP7480 764418-BS 764419-BS 761790 BP7480 764418-ORB 764419-ORB 761790 BP7480 764411-ORB 764412-ORB 764422 763493 760601 764420 762508 762508 764415-ORB * 764417-ORB 764421 — — — — — — — — — — — — — — — 764418-SW 764419-SW 761790 BP7480 764411-SW 764412-SW 764422-1 763493 760601 764420 762508 762508 764415-SW * 764417-SW 764421-1 — — — — — — — — — — — — — — — 764418-VNB 764419-VNB 7
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 18 NOTES 18 U.L. Model No.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 19 Emerson Air Comfort Ceiling Fan Limited Warranty What The Limited Warranty Covers: This limited warranty is offered by Air Comfort Products division of Emerson Electric Co.
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 20 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Questions, problems, missing parts: Before returning to the store call Emerson Electric Customer Service 8 a.m. - 6 p.m., Eastern, Monday-Friday 1-800-654-3545 www.emersonfans.com Retain this manual for future use. Part No. F40BP74800000 Revision: 131218 Printed in China 12/13 Form No. BP7480 U.L. Model No.
