Owner`s manual

10
U.L. Model No.: CF5100
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
5.1
Connect the green grounding lead from the hanger ball
and the green grounding lead from the hanger bracket
to the grounding conductor of supply (this may be a
bare wire or wire with green colored insulation).
Securely connect wires with wire connectors supplied.
5.2
Securely connect the fan motor white wire to the supply
white (neutral) wire using wire connector supplied
(Figure 17). Securely connect the fan motor black and
blue wires to the supply black (hot) wire using wire
connector supplied (Figure 17). After connections have
been made, turn leads upward and carefully push leads
into the outlet box, with the white and green leads on
one side of the outlet box and the black and blue leads
on the other side of the outlet box.
5. How to Wire Your Ceiling Fan
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
WARNING
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING
!
NOTE: CEILING COVER,
SUPPLY WIRES AND FAN
WIRES OMITTED FOR
CLARITY.
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
Figure 16
GROUND
WIRE
LISTED WIRE
CONNECTOR (3)
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
GREEN WIRE
(GROUND) FROM
HANGER BALL
WHITE SUPPLY
(NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY
WIRE (HOT)
BLACK
FAN WIRE
BLUE FAN WIRE
NOTE: CEILING COVER
OMITTED FOR CLARITY.
Figure 17
4. How to Hang Your Ceiling Fan (continued)
4.3
Carefully lift the fan and seat the hanger ball/
downrod assembly on the hanger bracket that was just
attached to the outlet box (Figure 16). Be sure the
groove in the ball is lined up with tab on the hanger
bracket (Figure 15).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 10