Owner`s manual

13
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF5100
10. Accent Light Harness Installation
10.1
NOTE: If you are planning to install an optional
Emerson Accent Light Fixture on your ceiling fan,
remove the coupler cover at this time for
installation.
Locate the yellow wire terminated by a wire connector
on top the motor housing assembly (Figure 20).
BROWN
WIRE
DO NOT REMOVE THESE
WIRE CONNECTORS
RED WIRE
YELLOW WIRE
CONNECTOR FROM
MOTOR
MOTOR COUPLING
DOWNROD
COUPLER
COVER
Figure 20
10.2
Separate, untwist and unkink the 80” accent light
harness yellow wire (supplied with the fan) . Join the 80”
accent light harness yellow wire to the motor housing
yellow connector (Figure 21).
Feed the accent light harness yellow wire through the
down rod, coupler cover and ceiling cover.
NOTE: The red and brown wires coming from the
top of the motor are capped with wire connectors.
DO NOT remove these connectors.
10.3
An accessory control is required to operate the optional
accent light. See accessory control for wiring
instructions.
YELLOW WIRE
CONNECTOR FROM
MOTOR
ACCENT LIGHT HARNESS
YELLOW WIRE
BROWN
WIRE
DO NOT REMOVE THESE
WIRE CONNECTORS
RED WIRE
MOTOR COUPLING
DOWNROD
COUPLER
COVER
Figure 21
BP7480 CF5100 PENBROOKE SELECT 12/18/13 10:35 AM Page 13