Instructions / Assembly

Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is
completed, place a check mark in the box. This will insure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One hanger ball/downrod assembly
g. One hanger bracket
h. One coupling cover
i. One loose parts bag containing:
1. Sixteen M5 x 6mm slotted Phillips
washer head blade screws
2. One M6 x 14mm Phillips head screw with
lockwasher
3. One wood pendant (large)
4. One wood pendant (small)
5. Two couplings
6. Three wire connectors
7. Two threaded studs
8. Two lockwashers
9. Two knurled knobs
3
10. One clevis pin
11. One hairpin clip
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan motor assembly from the
protective plastic bag. Place the fan assembly into
the upper foam pad with the top of the motor
facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
WARNING
!
WARNING
!
FAN BLADES
CEILING
COVER
SWITCH
HOUSING
ASSEMBLY
LOOSE
PARTS BAG
FAN BLADES
FLANGES
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
COUPLING
COVER
MOTOR
ASSEMBLY
How to Put Your Ceiling Fan Together
1. Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in step 5.
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 1
2. Unscrew the two setscrews (Figure 2) until they
clear the inside of the motor coupling. Then
separate, untwist and unkink the three 80” motor
leads. Route the motor lead wires through the
downrod. Align the clevis pin holes in the downrod
with the holes in the motor coupling. Install the cle-
vis pin and secure with the hairpin clip (Figure 2).
The clevis pin must go through the holes in the
motor coupling and the holes in the downrod. Be
sure to push the straight leg of the hairpin clip
through the hole near the end of the clevis pin until
the curved portion of the hairpin clip snaps around
the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working
loose. Pull on the downrod to make sure the clevis
pin is properly installed.
U.L. Model No.: 51-OD