Instructions / Assembly

ManualsBrandsEmerson ManualsCeiling FansDesigner 52 in. LED Oil Rubbed Bronze Ceiling Fan

If you feel that you do not have enough electrical

wiring knowledge or experience, have your fan

installed by a licensed electrician.

1. Connect the green grounding lead from the hanger

ball and the green grounding lead from the hanger

bracket to the grounding conductor of supply (this

may be a bare wire or wire with green colored

insulation). Securely connect wires with wire

connectors supplied.

NOTE: If you are using an Emerson Light Fixture

with your fan, see Light Fixture Owner’s Manual

for wiring.

2. Securely connect the fan motor white wire to the

supply white (neutral) wire using wire connector

supplied (Figure 12). Securely connect the fan

motor black wire and blue wire to the supply black

(hot) wire using wire connector supplied (Figure

12). After connections have been made, turn leads

upward and carefully push leads into the outlet box,

with the white and green leads on one side of the

outlet box and the black and blue leads on the

other side of the outlet box.

How to Wire Your Ceiling Fan

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before wiring.

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice,

as it must be grounded for safe operation.

GROUND

WIRE

LISTED

WIRE

CONNECTOR (3)

GREEN WIRE

(GROUND) FROM

HANGER BRACKET

GREEN WIRE

(GROUND) FROM

HANGER BALL

WHITE SUPPLY

(NEUTRAL)

WHITE FAN

WIRE

BLACK SUPPLY

(HOT)

BLACK AND BLUE

FAN WIRES

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not

operate fan until blades are in place. Noise and fan

damage could result.

Figure 12

NOTE: CEILING COVER

OMITTED FOR CLARITY.

OUTLET

BOX

HANGER

BRACKET

HANGER BALL/

DOWNROD ASSEMBLY

NOTE: CEILING COVER,

SUPPLY WIRES AND

FAN WIRES OMITTED

FOR CLARITY.

Figure 11

To avoid possible fire or shock, do not pinch wires

between the hanger ball/downrod assembly and

hanger bracket.

WARNING

How to Hang Your

Ceiling Fan

The fan must be hung with at least 7' of clearance

from floor to blades (Figure 9).

Hanger bracket must seat firmly against outlet box. If

the outlet box is recessed, remove wall board until

bracket contacts box. If bracket and/or outlet box are

not securely attached, the fan could wobble or fall.

Failure to seat tab in groove could cause damage to

electrical wires and possible shock or fire hazard.

AT LEAST

CEILING

FLOOR

Figure 9

2. Carefully lift the fan and seat the hanger

ball/downrod assembly on the hanger bracket that

was just attached to the outlet box (Figure 11). Be

sure the groove in the ball is lined up with tab on

the hanger bracket (Figure 10).

WARNING

1.Securely attach the hanger bracket to the outlet box

using the two screws supplied with the outlet box.

(Figure 10.)

The outlet box and joist must be securely mounted and

capable of supporting at least 50 lbs. Use only a U.L.

outlet box listed as “Acceptable for Fan Support”.

WARNING

To reduce the risk of fire, electrical shock, or personal

injury, mount fan to outlet box marked “Acceptable for

Fan Support”, and use screws supplied with outlet box.

Most outlet boxes commonly used for support of light

fixtures are not acceptable for fan support and may

need to be replaced. Consult a qualified electrician if

in doubt.

WARNING

TWO SCREWS

SUPPLIED WITH

OUTLET BOX

HANGER

BRACKET

TAB

OUTLET

BOX

Figure 2

Figure 10