Instructions / Assembly

8
U.L. Model No.: CF765-1
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the grounding conductor of supply (this
may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connectors supplied. (Figure 10.)
How to Wire Your Ceiling Fan & Install the Control
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal injury
or property damage.
WARNING
!
2. Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector
supplied (Figure 10). Securely connect the fan motor
black wire to the supply black (hot) wire using wire
connector supplied (Figure 10). After connections
have been made, turn leads upward and carefully
push the leads into the outlet box, with the wires
spread apart and the white and green leads on one
side of the outlet box and the black leads on the
other side of the outlet box.
3. Screw the two 1-1/4” threaded studs (supplied) into
the tapped holes in the hanger bracket (Figure 11).
4. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 11).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
THREADED
STUD (2)
HANGER
BRACKET
WHITE
SUPPLY
(NEUTRAL)
GREEN WIRE (GROUND)
FROM HANGER BRACKET
LISTED WIRE
CONNECTOR (3)
SUPPLY GROUND
WIRE
GREEN WIRE
(GROUND) FROM
HANGER BALL
BLACK FAN WIRE
BLACK
SUPPLY
(HOT)
WHITE
FAN WIRE
Figure 10
THREADED
STUDS (2)
#8 LOCKWASHER
KNURLED KNOB
CEILING
COVER
Figure 11
5. Secure the ceiling cover in place by sliding
lockwashers over the threaded studs and installing
the two knurled knobs (supplied) (Figure 11). Tighten
the knurled knobs securely until the ceiling cover fits
snugly against the ceiling. Your fan is now wired to
be turned on and off from the wall switch.
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
WARNING
!