Owner`s manual

SWITCH HOUSING/
LIGHT KIT FITTER
ASSEMBLY
SWITCH HOUSING
ASSEMBLY
CONNECTOR
MOTOR HOUSING
CONNECTOR
Figure 10
FINIAL NUT
OUTER
BOWL CAP
60-WATT
CANDELABRA
BASE LIGHT
BULB (3)
SWITCH HOUSING/
LIGHT KIT FITTER
ASSEMBLY
Figure 11
7
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF776
THREADED NIPPLE
LIGHT FITTER
GLASS
BOWL
60-WATT
CANDELABRA
BASE BULBS (3)
FINIAL NUT
OUTER BOWL
CAP
FAN SWITCH
CHAIN
LIGHT SWITCH
CHAIN
PENDANTS (2)
Figure 12
20. Install three 60-watt (maximum) candelabra base
light bulbs (included) into the light fitter sockets
(Figure 11).
21. Remove the finial nut and outer bowl cap from the
light fitter (Figure 12).
22. Pass the fan switch chain through the bushing in
the bowl cap (Figure 12).
23. Position the glass bowl over the threaded nipple.
Slide the outer bowl cap onto the threaded
nipple and gently tighten the finial nut to secure the
glass bowl. Pass the fan pull chain through the
bushing in the outer bowl cap and install the cap on
the threaded nipple. Install finial nut finger tight
(Figure 12).
CAUTION
Be sure that the fan switch chain does not make
contact with the light bulbs. If necessary
reposition the light fitter to avoid the fan switch
chain from touching the light bulbs.
24. Install pendants onto light fixture chain and fan
switch chain using couplers provided.
NOTE: It is advisable to periodically check the
tightness of the finial.
25. You have now completed the assembly of your new
ceiling fan. You can now proceed with hanging and
wiring your fan.
Over lamping the fan will result in the light bulbs being
automatically shut off. Use only 60-watt maximum
candelabra light bulbs. Turn off the electricity before
replacing the light bulbs.
WARNING
!
To avoid possible fire hazard, do not exceed wattage
indicated on the fitter.
WARNING
!