Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
TB1
TB2
Figure 4-1. Connectors TB1 and TB2
4.2 Setting the Operating Mode (Run/Remote/Local Switch or Mode
Switch)
The PSSM you receive has either a key-operated Run/Remote/Local
switch (see Figure 2-9) or a Mode switch (see Figure 2-10).
Run/Remote/
Local Switch
You set the PSSM’s Run/Remote/Local switch using a removable key.
You can remove this key when the switch is in any position to prevent
an unauthorized person from changing the operating mode.
Figure 4-2. Run/Remote/Local Key Switch
Run prevents you from performing any ControlWave Designer debug
or program functions (start/stop, application downloads, etc.). Remote
and Local functions depend on how you configured the communication
port in ControlWave Designer (serial, IP, or OpenBSI).
 IP/OpenBSI (BSAP): If you configure the communication port for
either of these choices in ControlWave Designer it becomes a
remote port: set the Run/Remote/Local switch to Remote for
downloads.
 Serial: If you configure the communication port for serial in
ControlWave Designer, it becomes a local port: set the
Run/Remote/Local switch to Local for downloads.
Note: Setting the Run/Remote/Local switch to Local enables
communications through any comm port. However, if you
set the switch to Remote, that restricts communications only
to comm ports configured as remote comm ports.
4-2 Operation Revised May-2011