Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
5-10 Service & Troubleshooting Revised May-2011
Module LED Name LED Color Function
ECOM2 EC6/10 RX (Comm 6/10)
1
Red ON = RX activity (3
rd
from top left; see Figure
5-8)
ECOM2 EC6/10 TX (Comm 6/10)
1
Red ON = TX activity (3
rd
from top right; see Figure
5-8)
ECOM2 EC7/11 RX (Comm 7/11)
1
Red ON = RX activity (bottom left;; see Figure 5-8)
ECOM2 EC7/11 TX (Comm 7/11)
1
Red ON = TX activity (bottom right; see Figure 5-8)
IDI INPUT (16 LEDs,1 per point) Red LED ON = Input is present
LED OFF = Input not present (see Figure 5-9)
IDO OUTPUT (16 LEDs,1 per
point)
Red LED ON = Output is ON (see Figure 5-9)
DI/O
IDI/O
INPUT (12 LEDs, 1 per point) Red LED ON = Input is present
LED OFF = Input not present (see Figure 5-9)
DI/O
IDI/O
OUTPUT (4 LEDs, 1 per point) Red LED ON = Output is ON (see Figure 5-9)
HSC INPUT (4 LEDs, 1 per point) Red LED ON = Input activity on input is present
LED OFF = No activity on input (see Figure 5-
9)
MI/O DI INPUT (6 LEDs, 1 per
point)
Red LED ON = Input is present
LED OFF = Input not present (see Figure 5-9)
MI/O DI INPUT (6 LEDs, 1 per
point)
Red LED ON = Output is ON (see Figure 5-9)
MI/O HSC INPUT (2 LEDs, 1 per
point)
Red LED ON = Input activity on input is present
LED OFF = No activity on input (see Figure 5-
9)
IDI (Vac) INPUT (8 LEDs, 1 per point) Red LED ON = Input is present
LED OFF = Input not present (see Figure 5-9)
IDO
(Vac/dc)
OUTPUT (8 LEDs, 1 per point) Red LED ON = Output is ON (see Figure 5-9)
1
Radio or modem with Type 1 comm board only
PSSM System
Status LED
Codes
As the Micro runs its application, status codes post to the six LEDs on
the PSSM. Table 5-2 provides activity descriptions of the LEDs;
Figure 5-5 shows what the LEDs look like for each hex code.
Table 5-2. System Status LED Codes on PSSM
Status in
Hex LED 6 ED 5 LED 4 LED 3 LED 2 LED 1 Activity Indicator
00 0 0 0 0 0 0 Application Running
01 0 0 0 0 0 1 Unit in Diagnostic Mode
03 0 0 0 0 1 1 Unit Running Diagnostics
04 0 0 0 1 0 0 Flash XSUM Error
05 0 0 0 1 0 1 Error Initializing Application Device
07 0 0 0 1 1 1 Flash Programming Error
08 0 0 1 0 0 0 Using Factor Defaults (flashed at start)