Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised May-2011 Service & Troubleshooting 5-11
Status in
Hex LED 6 ED 5 LED 4 LED 3 LED 2 LED 1 Activity Indicator
09 0 0 1 0 0 1 Battery Failure Detected (flashed at
startup)
0A 0 0 1 0 1 0 Currently Loading the Boot Project
0B 0 0 1 0 1 1 System Initialization in Progress
10 0 1 0 0 0 0 Waiting in Recovery Mode
11 0 1 0 0 0 1 Error Testing SDRAM
12 0 1 0 0 1 0 Error Testing SRAM
20 1 0 0 0 0 0 Application Loaded
28 1 0 1 0 0 0 Stopped at Break Point
30 1 1 0 0 0 0 No Application Loaded
38 1 1 1 0 0 0 Running with Break Points
3B 1 1 1 0 1 1 Waiting for a Power-down (after NMI)
3E 1 1 1 1 1 0 Waiting for Updump to be Performed
3F 1 1 1 1 1 1 Unit Crashed (Watchdog Disabled)
Figure 5-5. PSSM Status LED Hexadecimal Codes
CPU Module
LEDs
The CPU module has four or six comm port activity LEDs on the CPU
board. Units equipped with an Ethernet port have two additional LEDs
located on each Ethernet RJ-45 connector. Table 5-3 details
assignments for the LEDs on the CPU module.