Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised May-2011 Radio Installation D-5
D2.1 Modem Installation & Configuration
D2.1.1 Installing an Internal MultiTech Modem (MT9234SMI)
To install a Model MT9234SMI Modem onto an ECOM Module,
perform the following steps:
1. Remove the ECOM Module from the controller (see Figure D1).
2. Unplug the antenna cable from the RF Connector on any installed
radio module. Grasp the ECOM Module with one hand. Squeeze
both sides of the cover panel (just below the unit’s top) and pull up
and away to release the cover panel and EMI Gasket from the PCB
(see Figure D4).
Note: If necessary, you can use a small screwdriver to pry the cover
panel from the PCB.
3. Install the nylon support post included in the kit onto the ECOM
Module.
4. Mount the MultiTech Modem to the ECOM Module making sure
that the interface connectors (J6, J7, J9 & J10 on the ECOM
Module) align.
5. Plug the antenna cable(s) (if present - removed in Step 2) into the
appropriate RF connector of an installed radio module(s).