Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
T
ransm
it LED
s
Receive LEDs
Revised May-2011 Installation 2-35
If In Slot #3
Comm. Port
Assignments
If In Slot #4
OPTION
Populated
by
Order
FreeWave
Radio
Modem
Modem
Comm. Port 4/8 Status LEDs
Comm. Port 7/11 Status LEDs
Comm. Port 6/10 Status LEDs
Comm. Port 5/9 Status LEDs
Comm. Port 4/8
RS-232
Comm. Port 5/9
RS-485
Radio Port
Modem Port
4
5
7
6
8
9
11
10
Figure 2-26. ECOM Radio Modem Installation
2.5.4 Modem Port (Type 1 ECOM only)
You can mount an optional 56Kb PSTN Hayes-type modem on a Type
1 ECOM (see Figure 2-26).
The ControlWave Micro then assigns the modem COM7 (if in slot #3)
or COM11 (if in slot #4).
You can configure the MultiTech model MT9234SMI modem module
for publicly switched telephone network (PSTN) operation. You can
also clock DTE/DCE serial data into (transmit) or out of (receive) the
modem at rates up to 115.2 kHz.
The factory supplies the modem pre-installed or in kit form with all
required hardware. You install it on the ECOM1 module and then use
the Ports page in the Flash Configuration utility (in NetView or