Electronic Window Air Conditioner M ODEL: 6,000 BTU 8,000 BTU 10,000 BTU 12,000 BTU Thank you very much for purchasing our air conditioner.Please read this owner`s manual carefully before using your air conditioner.
INTRODUCTION IMPORTANT SAFETY INSTRUCTION ...........................................................................1 ELECTRICAL REQUIREMENTS ................................................................................... 2 PACKING LIST ............................................................................................................3 INSTALLATION & ASSEMBLY INSTRUCTIONS ............................................................. 4 USING YOUR AIR CONDITIONER ................................
below: 1
(6K-8K) 0-8 amps (10K-12K) 0-12 amps (6K-8K) 10-amp (10K-12K) 15-amp 2
3
FIG. 1 8 STOOL OFFSET SILL EXTERIOR WALL INTERIOR WALL FIG.
(Only used for 6K/8K) 6K-8K Head 10K-12K 5
3 FIG. 3 Head FIG. 4 FIG.
FIG. 10 (Suggest to keep a downward angle, to let accumulated rain water to drain out, from back side of the unit bottom.) FIG. 6 FIG. 11 FIG. 7 FIG. 12 FIG. 8 FIG. 13 FIG.
FIG.
Cool Mode: The cooling function allows the air conditioner to cool the room and at the same time reduces humidity. Press the MODE button to activate the cooling function. To optimize this function adjust the temperature by pressing the up and down arrows and the speed by pressing the Fan Speed button. Dry Mode: This function reduces the humidity of the air to make the room more comfortable. Press MODE button to set the DRY mode. An automatic function of alternating cooling cycles and air fan is activated.
10. Directional Louvers: Use the horizontal wheels 6. Eco Button: When the unit is in ECO mode, the to control horizontal airflow and the air deflectors light will turn on. In ECO mode, the unit will to control vertical airflow. turn-off once the room is cooled to the user set temperature. The fan will also be off at this point. The unit will turn back on when the room temperature rises above the user set temperature.
1 5. Timer: Use buttons on the control panel and remote to set the TIMER. Timer Off: The timed stop is programmed by pressing TIMER button. Set the stop time by until your pressing the button or desired stop time is displayed, then press TIMER button again. Timer On: When the unit is off, press TIMER button first, set the temperature with pressing the button or . Press TIMER button a second time, set the stop time with pressing the button or .
The Check Filter light will automatically turn on after the fan motor has been in operation for a total of 500 hours. 15 FIG.
13
For any questions or Technical Support, Please Call Customer Service: 1-844-801-8880 14
