PANTONE Cool Gray 10 CVC PANTONE 653 CVC 10% BLACK 20% BLACK Electronic Window Air Conditioner MODEL: 5,000 BTU 6,000 BTU 8,000 BTU 10,000 BTU 12,000 BTU Thank you very much for purchasing our air conditioner.Please read this owner`s manual carefully before using your air conditioner.
TABLE OF CONTENTS AIR CONDITIONER SAFETY 2 INSTALLATION REQUIREMENTS 3 Electrical Requirements Tools and Parts Unpack the Air Conditioner Location Requirements INSTALLATION INSTRUCTIONS Prepare Air Conditioner for Installation Window Air Conditioner Installation Complete Installation 3 4 4 5 6 6 6 8 AIR CONDITIONER USE 8 9 11 12 12 12 AIR CONDITIONER CARE 13 Starting Your Air Conditioner Using the Remote Control Changing Air Direction Exhaust Air Vent Normal Sounds Cleaning the Air Filter Cleani
AIR CONDITIONER SAFETY You safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING".
INSTALLATION REQUIREMENTS Electrical Requirements WARNING Wiring requirement 115 V (103.5 V min. to 126.5 V max.) 10 A time-delay fuse or circuit breaker for 5K/6K cooling only 13 A time-delay fuse or circuit breaker for 8K cooling only Electrical Shock Hazard Plug into a grounded 3 prong outlet. 15 A time-delay fuse or circuit breaker for 10K/12K cooling only Do not remove ground prong. Do not use an adapter. Do not use an extension cord.
Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Parts supplied Check that all parts are included in parts package. A Tools needed ■ Phillips screwdriver ■ Tape measure G E F B H ■ Scissors ■ Cordless drill and 1/8" bit J D ■ Level ■ I C K Pencil A. Adhesive seal (2) B. Foam seal C. lock frame (for Wooden windows)(2) K. Air conditioner L D. lock frame G.
Location Requirements Window Installation Before You Begin Read these instructions completely and carefully. ■ ■ ■ Note to Installer: Be sure to leave these instructions with the Consumer. ■ Note to Consumer: Keep these instructions for future reference. ■ Skill level: Installation of this appliance requires basic mechanical skills. ■ Completion time: Approximately 1 hour. ■ We recommend that two people install this product. Proper installation is the responsibility of the installer.
INSTALLATION INSTRUCTIONS Prepare Air Conditioner for Installation Attach Top Rail 2. Insert top and then bottom of right-hand curtain housing in top and bottom curtain rails on air conditioner. 1. Locate the bag of screws provided. 2. Place the top rail on top of the air conditioner cabinet, lining up the 4 holes in the top rail with the 4 holes on top of the air conditioner cabinet. 3. Using four 3/8" (10mm) screws, attach the top rail to the air conditioner cabinet. Back View A B A.
Window Air Conditioner Installation 1. Center air conditioner in window. Lower the window sash behind the top rail to hold cabinet in place. Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill and make sure the unit is staying center of the window. Carefully close the window behind the top rail of the unit. Seal Attach Side Curtains to Window 1.
Remove the backing from the EVA Foam. Attach one EVA Foam on the Curtain housing , the side with adhesive should facing the Curtain housing . Remark a line on the EVA Foam according to less 1/8 (3mm) than the measured width in, then cut the EVA Foam along the line. A A B B A. Curtain housing B. EVA Foam NOTE: The EVA Foam is not need to attach for Models: 5K/6K regular cooling only . 5. Repeat for the right-hand curtain. Complete Installation 1.
Starting Your Air Conditioner Low Med High Fan Dry Cool Eco ■ Timer Sleep Filter FAN CONNECT MODE ON/OFF ON/OFF Temperature 1. Press the power button to turn on the air conditioner. ■ Press the plus UP (∧) button to raise the temperature. Each time you press or hold the plus UP (∧) button, the temperature will go up 1°F (1°C) until it reaches 86°F (30°C).
Timer Sleep Filter 1. The LED light on control panel for Timer、Sleep、Filter. Timer Sleep Filter 2. The function introduction See “using the remote control”. WIFI WIFI control is available for connected models with this logo on control panel. CONNECT 1.Press the CONNECT button for 5s,the LED start to falsh. 2. After the WIFI module connecting the router,the LED keeps on.Or the LED keeps off. NOTE: WIFI control is ONLY available for WIFI control models.
NOTE: Remote control may differ in appearance. Using the Remote Control Temperature Press the plus UP (∧) button to raise the temperature. Each time you press or hold the plus UP (∧) button, the temperature will go up 1°F (1°C) until it reaches 86°F (30°C). ■ Press the minus DOWN (∨) button to lower the temperature. Each time you press or hold the DOWN (∨) button, the temperature will go down 1°F (1°C) until it reaches 61°F (16°C). ■ DIMMER Press the DIMMER button to turn off the control panel display.
Timer Filter 1. When the Filter indicator light is lit, remove, clean and replace the air filter. See “Cleaning the Air Filter”. 2. Press Power button on the machine, or FILTER button on remote to reset the filter , after cleaning and replacing the air filter. To set timer for a 1 – 24 hour delay on – off operation: 1. Press TIMER on remote control, LED display on the air conditioner control panel will flash. 2. Press up or down arrow button to change the delay time from 1 hour to 24 hours. 3.
AIR CONDITIONER CARE Your new air conditioner is designed to give you many years of dependable service. This section tells you how to clean and care for your air conditioner properly. Call your local authorized dealer for an annual checkup. Remember the cost of this service call is your responsibility. 3. Use a vacuum cleaner to clean the air filter. If the air filter is very dirty, wash it in warm water with a mild detergent.
TROUBLESHOOTING Before calling for service, try the suggestions below to see whether you can solve your problem without outside help. Air conditioner power supply cord trips (Reset button pops out) Air conditioner will not operate Electrical Shock Hazard WARNING Plug into a grounded 3 prong outlet. ■ Disturbances in your electrical current can trip (Reset button will pop out) the power supply cord.
■ The temperature of the room you are trying to cool is extremely hot. Allow extra time for the air conditioner to cool off a very hot room. ■ Windows or doors to the outside are open. Close all windows and doors. ■ The Temp control is not at a cool enough setting. Adjust the Temp control to a cooler setting by pressing the minus button to reduce the temperature. Set the Fan Speed control to the highest setting.
For any questions or Technical Support, Please Call Customer Service: 1-844-801-8880