Data Sheet
D4 Valve
D103039X012
Product Bulletin
51.2:D4
November 2013
4
Actuator Specifications
ELECTRIC ACTUATOR
Material Temperature Capabilities
(1)
Electric Actuator Assembly:
-20 to 70C(-4to158F) ambient
Available Electric Actuator Configurations
easy-Drive Electric On/Off
easy-Drive Electric Positioning
Power Requirements
12 or 24VDC, m inimum 4 amp power supply required
(fuse to 5 amps)
Maximum Current Draw
4amps
Conduit Connections
Two 3/4 NPT connections
Control Signals
On/Off: Dry contact, Modbus RTU
Positioning: 1-5VDC, 4-20 mA, Modbus RTU
Electrical Classification
Hazardous Area:
CSA (C/US) – Explosion proof
FM– Explosion proof (pending)
ATEX– Flameproof (pending)
IECEx– Flameproof (pending)
Refer to table 1 for specific approval information
Electrical Housing:
CSA -- Type 4X
FM -- NEMA 4X (pending)
ATEX -- IP66 (pending)
IECEx -- IP66 (pending)
Electromagnetic Compatibility
Meets EN 61326-1 (First Edition)
Immunity: Industrial locations per table 2 of EN
61326-1 Standard. Performance is shown in table 2
Emmissions: Class A
ISM Equipment Rating: Group 1, Class A
PNEUMATIC
ACTUATOR
Input Signal to Actuator
Seetables7,8,9,and10
Material Temperature Capabilities
(1)
Actuator Assembly:
Fail-Down, Spring-to-Close: -40 to 93C
(-40 to 200F)
Fail-Up, Spring-to-Open: -40 to 93C
(-40 to 200F)
Available Pneumatic Actuator Configurations
Spring-to-Open
Spring-to-Close
Maximum Actuator Casing Pressure
(1)
3.4 bar (50 psig)
Actuator Diaphragm Effective Area
452 cm
2
(69 square inches)
Actuator Pressure Connections
1/4 NPT internal
1. The pressure or temperature limits in the referenced tables and any applicable ASME code limitations should not be exceeded.