Brochures and Data Sheets

MCOV
120 Volt 150 VRMS
240 Volt 275 VRMS
Line Frequency 47 - 63 Hz
Response Time
Normal Mode < 0.5 ns
Common Mode < 5 ns
Operating Temperature
-40°C to +45°C at Full Load
Derate Linearly to 60% at +70ºC
Operating Humidity 0% to 95%
Peak Surge Current Capability (8 x 20 µs)
Line to Neutral 15,000 Amps
Line to Ground 15,000 Amps
Neutral to Ground 15,000 Amps
Load Surge Current Rating
10 mSec 5 x Nominal
1 sec 3 x Nominal
10 sec 2 x Nominal
Packaging
• High Impact Plastic Case
• Vacuum Impregnated Magnetics
• Epoxy Encapsulated
Frequency Response (Forward-Reverse)
Normal Mode 100 kHz to 50 MHz - 90 dB Min
Common Mode 5 MHz to 50 MHz - 60 dB Min
Typical Category A Ringwave (6 kV, 200 A, 100 kHz)
Model Normal Common
IC+102 / LRIC+102 1.0 / 0.9 302 / 287
IC+105 / LRIC+105 0.7 / 0.8 292 / 307
IC+107 / LRIC+107 0.7 / 0.7 302 / 293
IC+115 / LRIC+115 0.7 / 0.7 304 / 306
IC+130 / IC+202 0.5 / 1.1 306 / 536
IC+205 / IC+207 1.5 / 0.8 628 / 616
IC+215 / IC+230 0.6 / 0.9 572 / 566
Typical Category B Ringwave (6 kV, 500 A, 100 kHz)
Model Normal Common
IC+102 / LRIC+102 178 / 188 302 / 285
IC+105 / LRIC+105 162 / 191 291 / 300
IC+107 / LRIC+107 173 / 190 300 / 298
IC+115 / LRIC+115 153 / 149 307 / 309
IC+130 / IC+202 241 / 302 299 / 532
IC+205 / IC+207 378 / 336 594 / 596
IC+215 / IC+230 272 / 342 548 / 578
Series Blocking Inductors
voltage blocking current
smoothing inductors
Shunt Absorbing Components
sine wave tracking circuitry
MOV Transient Protection
high-energy transient
protection line to neutral,
line to ground,
neutral to ground
Pulse Capacitor
high-frequency noise absorption
Islatrol
™
IC+/LRIC+ Series
Active Tracking Filter
™
Series connected high-frequency noise filter with transient protection. Offers
the flexibility of either receptacle/line cord connection or hard-wired connection
to critical loads (up to 30 Amperes). Applications include industrial or office
equipment, computers placed in harsh environments.
Features
■ Typically reduces normal mode transients
to +/-2 volts
■ Surge current capacity — 45,000 Amps
■ Transient protection in all modes: line
to neutral, line to ground, and neutral
to ground
■ LED power indication
■ UL 1283, CSA recognized
■ 10 year warranty
Note: All measurements in volts. IEEE test results with
no AC applied. Normal mode—L1-N or L1-L2;
Common mode—L-G, N-G or L1-G, L2-G.
System Design
Connection Diagram
Filtering/Line Conditioning
TM
TM
Operating Voltage 130 VDC
Clamping Voltage 150 VDC
(DC Spark Over Voltage)
Operating Current 1 A
Peak Surge Current 10 kA (8 x 20 µs)
Maximum Power 10 Watts
Impedence 50 Ohms
Frequency Range 0 to 4 GHz
Insertion Loss < 0.3 dB to 0.5 dB 2 to 3 GHz
SPD Technology Gas Discharge Tube (GDT)
Connection Type Female N-Type
Operating Temperature -30°C to +85°C
Dimensions (Inches) 1.25H x .875W x 2.5L
Weight 4 oz
CX-HFN-FF (Female–Female)
CX-HFN-FM (Female-Male)
General Technical Specifications
Data/Signal Line Protection
17
Edco
™
RM-CAT6-POE Series
CAT6-POE Channel Rackmount
The Edco
™
RM-CAT6-POE Series is a multi-channel high-speed data line protector
that utilizes a three-stage hybrid design technology. This unit addresses high-
energy voltage transients that can damage expensive computer equipment. Ideal
for network switches and hubs, the Edco
™
RM-CAT6-POE Series is easily mounted
in close proximity to the protected equipment.
Operating Voltage 57 V
Clamping Voltage 68 V
Transmission Speed 10 Mbps,
100 Mbps, 1,000 Mbps
Operating Current 0.15 A
Connection Means 2-Port Series
SPD Technology GDT, SAD, W/Series PTC
Modes of Protection Signal High-Low,
Signal High-Ground,
Signal Low-Ground
Peak Surge Current 10 kA (8 x 20 µs)
Insertion Loss <0.1 dB
VSWR <1.2
Operating Humidity 0-95% Non-Condensing
Operating Temperature -40°C to +85°C
Input Connection Type RJ-45
Output Connection Type RJ-45
Mounting Rackmount
Enclosure Type Painted Steel
Dimensions 1.75Hx19Wx6.3D
Weight 5.5 lbs
Warranty 1 Year
RM-CAT6-8POE 8 Channels
RM-CAT6-16POE 16 Channels
RM-CAT6-24POE 24 Channels
RM-CAT6-48POE 48 Channels
Features
■ Exceeds category 6 transmission values
■ Compact 1U rack size
■ Meets Power-Over-Ethernet (POE)
requirements
■ Low insertion loss
■ Three stage hybrid
■ 1 year warranty
■ Replaceable surge modules
■ Up to 48 channels available
General Technical Specifications
Edco
™
CX-HFN Series
High Frequency Coax Protector — N-Type
The Edco
™
CX-HFN surge protectors are designed to protect sensitive electronic
equipment from damage due to excessive voltage or currents generated by
lightning or static build-up.
The Edco
™
CX-HFN offers low signal loss at frequencies up to 4 gigahertz. The unit
also has a replaceable protection cartridge (CX-RC). The Edco
™
CX-HFN
accommodates both bulkhead mount and stud mount. The input and output
connections are interchangeable.
Features
■ Low signal loss
■ 5 year warranty
Ordering Information
Ordering Information
8