Brochures and Data Sheets

Features
■ Plugs into standard 120 V, 15 Amp
electrical outlet
■ Total peak surge current capacity of
39,000 Amps
■ Cables for telephone, video, and
data connections
■ Repositionable outlets rotate to
accommodate available space
■ Perfect for tight spaces, behind furniture
and appliances
■ Intelligent monitoring against improper
wiring/grounding
■ 60 dB maximum high frequency
■ Operational indicator lamp
■ 5 year limited warranty
AC Power Protection
VPR L-N:330V, L-G:400V, N-G:400V
Nominal Operating Voltage 120 VAC, Single Phase
Operating Voltage Range 120 VAC +/- 10%
Operating Frequency Range 47 — 63 Hz
Rated Output (Amps) 15 Amperes
ANSI/IEEE C62.41 Category Category A & B
Connection Type (6) 5-15R Receptacles and
5-15P Plug
Phase Configuration 2 Wire + Gnd
Size 7.5 x 4.75 x 1.75 (Inches)
Enclosure High Impact Plastic
Weight 2.0 lbs (0.9 kgs)
Modes Of Protection L — N, L — G, N — G
Indication of Suppression Status Status Indicator
Response Time < .5 ns Normal Mode
Certifications ANSI/UL 1449 Third Edition Type 3
Warranty 5 Year
Maximum Continuous Operating Voltage (MCOV)
Line to Neutral 130 VAC
Peak Surge Current (8 x 20 ms)
Line to Neutral 13,000 Amps
Line to Ground 13,000 Amps
Neutral to Ground 13,000 Amps
Total 39,000 Amps
ANSI/IEEE C62.41 Cat A Ringwave (6 kV, 200 A, 100 kHz)
Normal Mode 265 V
Common Mode 290 V
ANSI/IEEE C62.41 Cat B Ringwave (6 kV, 500 A, 100 kHz)
Normal Mode 275 V
Common Mode 290 V
Frequency Response
Normal Mode 60 dB Maximum, forward/reverse, 100 kHz to 50 MHz
Common Mode 40 dB Maximum, forward/reverse, 5 MHz to 50 MHz
Low Voltage Protection
Video 1 & 2 Phone Network
Connection Type Type “F” Type RJ-11 Type RJ-45
Cables Provided 6' (2x) Type “F” 6' RJ-11 Male 6' RJ-45 Male
6' Ends 6' Ends Ends
Peak Surge Current 5 kA 2 kA 3 kA
(8 x 20 µs) (10 x 1000 µs) (8 x 20 µs)
Capacitance <12 pf <50 pf <70 pf
Protection Level L-G T-R, T-G, R-G L-G (8 Lines)
Clamping Voltage (DC) 145 V 270-350 V 30 V
Attenuation 1 dB @ 2 Ghz N/A N/A
General Technical Specifications
Islatrol
™
— SP-6TVN
Industrial Strength Surge Suppression (Series)
The Islatrol
™
SP-6TVN plug-in unit is an Active Tracking Filter
™
which plugs into
a standard duplex receptacle. It features uniquely designed repositionable
outlets for easy installation behind desks and other furniture. It protects
sensitive home or office equipment from damaging power disturbances
traveling through wiring to electrical outlets.
Filtering/Line Conditioning
Repositionable Outlets
Edco
™
PHC Series
Two-Pair Signaling Circuit Protector (Modular)
The Edco
™
PHC Series is designed to protect two pairs of wires specifically for
alarm and security systems where operating currents can be as high as 5 Amps.
Electrically, the Edco
™
PHC Series is a rugged series hybrid implementing a
staged complement of MOVs, copper wound inductors and Silicon Avalanche
Diodes. This design reduces series resistance to 0.2 Ohms per pair. These
products are intended to mate with an Edco PCB1B-WKEY gold-plated female
terminal connector.
The Edco
™
PHC modules plug into a base assembly (Edco
™
PCB1B-WKEY). The
base assembly can be mounted to any flat surface and should be located as close
as practical to the protected equipment. Terminal 1 and/or terminal 10 should
be connected to Building-Approved Ground with 12 or 10 gauge solid wire.
Features
■ Three-stage protection
■ Differential protection
■ Common mode protection
■ Plug-in module
■ Automatic recovery
■ Fast response time
■ Continuous current up to 5 Amps
■ UL 497B listed
■ Requires Edco
™
PCB1B-WKEY base
■ PC642PTU (Pass Thru Unit)
available for troubleshooting
■ 5 year warranty
Operating Voltage 36-70 VDC
Clamping Voltage 43-100 VDC
Operating Current 5 A
Peak Surge Current 10 kA (8 x 20 µs)
Frequency Range 0 to 10 MHz
Insertion Loss < 0.1 dB at 10 MHz
SPD Technology MOV, SAD, w/Series Inductor
Connection Type Terminal block
w/compression lugs
Terminals accept up to 10 AWG
Operating Temperature -40°C to +85°C
Dimensions (Inches) 3.7H x 1.75W x 2.375L
(PHC + Mounting Base)
Weight 8 oz
Certifications UL 497B
24V Horn, Strobe, Bell: PHC-043 & PCB1B-WKEY
70V Speaker Lines: PHC-SP70 & PCB1B-WKEY
-WKEY
- WKEY
- WKEY
General Technical Specifications
Dimensions
Terminal Assignments
Ordering Information
EDCO PCB1B-WKEY BASE SOLD SEPARATELY
Applications Part Number
DO NOT daisy chain grounds. NOT intended for shield
termination. Install ground in accordance with all
applicable codes.
How to Specify the Appropriate Model
Data/Signal Line Protection
15
10