MLT Analyzer Module Manual

5 - 62
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
Main Menu — Analyzer and I/O-module expert configuration
↓↓
Analyzer module setup
↓↓
Flow measurement
↓↓
In the menu "Flow Measurement" you can set up the flow unit for the current channel of an
MLT analyzer or analyzer module. In the last line of this menu you will find the actual flow
of the channel selected.
Flow unit setup:
♦ Press the 88 -key or the →→ -key to select the variable.
♦ Select the unit with the ↑↑ -key or the ↓↓ -key.
Options: ml/min, l/min
♦ Confirm your adjustment with the 88 -key or
cancel and go back to the last one with the F2 key.
Note:
If no flow sensor is installed, you will find a corresponding message on the screen instead
of the menu page shown above.
Measure Back...
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- Flow Measurement --
Unit: ml/min
Flow: 23.0 ml/min
Flow measurement is: Valid
[2nd menu page via F5 (More...)]
5.1 Analyzer Module Setup
5.1.15 Flow Measurement