MLT Analyzer Module Manual

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 63
Main Menu — Analyzer and I/O-module expert configuration
↓↓
Analyzer module setup
↓↓
Temperature measurement
↓↓
In the menu "Temperature Measurement" you can set up the temperature unit for the
current channel of an MLT analyzer or analyzer module. In the last line of this menu you
will find the actual temperature of the channel selected.
Temperature unit setup:
♦ Press the 88 -key or the →→ -key to select the variable.
♦ Select the unit with the ↑↑ -key or the ↓↓ -key.
Options: °C, °F
♦ Confirm your adjustment with the 88 -key or
cancel and go back to the last one with the F2 key.
Note:
If no temperature sensor is installed, you will find a corresponding message on the screen
instead of the menu page shown above.
Measure Back...
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- Temperature Measurement --
Unit: F
Temperature: 77.0 F
Temperature measurement is: Valid
[2nd menu page via F5 (More...)]
5.1 Analyzer Module Setup
5.1.16 Temperature Measurement