MLT Analyzer Module Manual

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 13
Further Parameters:
Via the F5 key (ShowList) you can change to the following submenu:
In this submenu you can determine some further parameters of the time controlled
calibration.
Lines "Position in auto-start list", "Erase current position from list !" and
"Erase all positions from list !":
If you have disabled a time controlled calibration in the menu "Time Control" you have to
reset the memory to avoid further calibrations by time control. Starting the function "Erase
current position from list !" will reset the memory for the position selected in the line
"Position in auto-start list".
There are three positions belonging to the following lines in the menu "Time Control":
Position 1: Zero calibration
Position 2: Span calibration
Position 3: Zero+Span calibration
Starting the function "Erase all positions from list !" will delete the set-ups for all kinds of
time controlled calibration in the menu "Time Control".
The last five lines of variables:
These lines will display the parameters of the position selected in the line "Position in
auto-start list".
Measure Back...
TAG
F1 F2 F3 F4 F5
37.50 ppm
-- Auto-Start Procedures --
Position in auto-start list: 1
Erase current position from list !
Erase all positions from list !
Channel tag: -
Procedure type: -
Start time: -
Start date: -
Interval mode: Never