Installation manual

65
Setting Up Parameters
Figure 50: Output Lines View for a Epsilon EP-B Drive
For wiring information, refer to the “Installation” section of the Epsilon EP Installation Manual (P/N 400518-01).
Output Function Window
This window allows selection of the output function to be assigned to an output line.
To assign an output function, position the mouse pointer over the function on the left to assign it to the line on the right.
Press the left mouse button while over the function, and hold the button down. While holding the left button down, drag
the function until the pointer is positioned over the desired line and release the left mouse button.
To unassign an output function, position the pointer over the function on the left. Press the left mouse button while over
the function, and hold the button down. While holding the left button down, drag the function over to the right and release
the left mouse button.
Output Lines Window
Attached Function
This feature displays the Output Function assigned to each particular Output Line.
Configuration
The configuration of each output line is displayed nest to the output line when the active state is changed from default.
The default configuration is Active On, see Active Off check box below.
Output Lines Group
Active Off Check Box
The default active state of an output line is "Active On". This means that the output line will supply a voltage when the
result of the logical Or of the output function(s) assigned to that output line is active.
Making an output line "Active Off" means that the line will be “Off” (not conducting) when the result of the logical Or of
the output function(s) assigned to that output line is active, and will supply a voltage when the logical Or of the output
function(s) is not active.
Forced Off and Forced On Check Boxes
You can force an input line to a level by using the Forced On and Forced Off check boxes. When you force an input line
on or off, all the functions assigned to that line will be affected. This check box is only available to select when online
with the drive.
The forced state of the input and output lines are not saved to NVM and will reset to normal operation when the
drive is powered up or re-booted.