Installation manual

Safety Information ix
Safety Information Product Overview Installation Diagnostics
Options and
Accessories
Specification
CE Declaration of Conformity
The Epsilon Digital Servo Drives are marked with the “Conformite Europeenne Mark” (CE mark) after passing a
rigorous set of design and testing criteria. This label indicates that this product meets safety and noise immunity and
emissions (EMC) standards when installed according to the installation guidelines and used within the product
specifications.
Declaration of Conformity
Manufacturer’s Name:
Control Techniques Americas LLC
Manufacturer’s Address:
12005 Technology Drive
Eden Prairie, MN 55344
USA
Declares that the following products:
Product Name:
Epsilon EP Digital Servo Drive
Model Number:
EP202-B00, EP202-I00, EP202-IDN, EP202-P00, EP202-PDN, EP202-PPB,
EP204-B00, EP204-I00, EP204-IDN, EP204-P00, EP204-PDN, EP204-PPB,
EP206-B00, EP206-I00, EP206-IDN, EP206-P00, EP206-PDN, EP206-PPB,
EP209-B00, EP209-I00, EP209-IDN, EP209-P00, EP209-PDN, EP209-PPB,
EP216-B00, EP216-I00, EP216-IDN, EP216-P00, EP216-PDN, EP216-PPB
System Options:
STI-24IO Interface Board, STI-SNCOA Analog/Sync Output Interface Board,
STI-SNCI Sync Input Interface Board, BRM-1 Motor Brake Relay, and SM-
Heatsink DBR-1 Brake Resistor
Conforms to the following product specification:
Electomagnetic Compatibility (EMC):
EN 61800-3; 1997, For second environment restricted distribution
Electrical Thermal and Energy Safety Requirements:
EN 61800-5-1:2003
Supplementary information:
The products herewith comply with the requirements of the Low Voltage Directive (LVD) 73/23/EEC and amended by 93/
68/EEC and the EMC Directive 89/336/EEC
This servo drive is intended to be used with an appropriate motor, electrical protection components and other equipment
to form a complete end product or system. It must be installed by a professional assembler who is familiar with safety
and electromagnetic compatibility (“EMC”) requirements. The assembler is responsible for ensuring that the end product
or system complies with all the relevant laws in the country where it is to be used. Refer to the product manual for
installation guidelines.
December 12, 2006
Steve Bartz, Director, Motion Control Product Line Date
European Contact:
Sobetra Automation
Langeveldpark Lot 10
P. Dasterleusstraat 2
1600 St. Pieters Leeuw, Belgium