Installation manual

Installation 7
Safety Information Product Overview Installation Diagnostics
Options and
Accessories
Specification
Cable to Enclosure Shielding
Shielded motor, feedback, serial communications and external encoder cables were used for compliance testing and
are necessary to meet the EMC requirements. Each cable shield was grounded at the enclosure wall by the type of
grommet described earlier and shown in the following figure.
Figure 4: Through Wall Shield Grommet
Cable Type Cable Model
Shielded Cable Grommet
Kit Model
Actual Hole Size
Motor Cable, 18 Ga XTMDS CGS-047 0.8125 or 13/16"
Motor Cable, 16 Ga
CMDS CGS-047 0.8125 or 13/16"
4X16SS CGS-047 0.8125 or 13/16"
Motor Cable, 18 Ga XCMDS CGS-047 0.8125 or 13/16"
Motor Cable, 12 Ga
CMMS CGS-069 1.125 or 1 1/8"
4X12SS CGS-069 1.125 or 1 1/8"
Feedback Cable
CFOS CGS-047 0.8125 or 13/16"
MGFS CGS-047 0.8125 or 13/16"
Flex Motor Cable, 16 Ga
CMDF CGS-047 0.8125 or 13/16"
4X16SF CGS-047 0.8125 or 13/16"
Flex Motor Cable, 12 Ga
CMMF CGS-069 1.125 or 1 1/8"
4X12SF CGS-069 1.125 or 1 1/8"
Flex Feedback Cable
CFCF CGS-069 1.125 or 1 1/8"
CFOF CGS-069 1.125 or 1 1/8"
MGFF CGS-069 1.125 or 1 1/8"
External Encoder ENCO CGS-047 0.8125 or 13/16"
AC Power user supplied user supplied user supplied
Cable Jacket
After tightening lock nut and positioning cable
so that Spring Contacts are contacting the
cable shield, tighten Cable Seal Housing.
Remove 1/2 to 1 inch of cable jacket.
The Spring Contacts will make a continuous
electrical path from the shield of the cable to
equipment ground.
When Lock Nut is tightened to inside of
enclosure, lock nut will cut through varnished,
anodized, and powder coated finishes.
Tighten lock nut so it cuts through the
finish and into housing.
Outside Enclosure
Cable Shielding
Spring Contacts
O-Ring seals against outside of enclosure
to meet IP68 (comparable to NEMA 6)
Inside Enclosure