Installation manual

ManualsBrandsEmerson ManualsHome building and DecorEpsilon EP Drive 400518-01

Safety Information Product Overview Installation Diagnostics

Options and

Accessories

Specification

XV Motor Power Wiring

The XV 40 mm to 80 mm motors are equipped with up to three connectors, one for stator connections, one for

encoder connections and one for the brake (if so equipped).

Stator connections from the drive to the motor are made using the XTMDS cable, the motor end of the cable has an

Amp "Mate-N-Lok"® connector and the drive end has four individual wires and shield that connect to the motor power

connector on the front of the drive.

Figure 27: Epsilon EP202-EP206 - XV 40 mm - 80 mm Motor Power Wiring Diagram

Figure 28: Epsilon EP209 - XV 40 mm - 80 mm Motor Power Wiring Diagram

XVM 40M, 60M, 80M Motor

Power Connection

Ground

Connector Shell

Brown

Black

Blue

Green/Yellow

Shield

Important: PE ground

should connect to drive

and motor only. Nothing

should be connected

between these devices.

motor cable

connector (XTMDS-xxx)

Wire crimp ferrules are recommanded:

For ground lead use -

Pheonix Contact p/n AI-TWIN 2X1-8RD/32 00 81 0 or

American Electrical/DigiKey 1381010/288-1127-ND

For motor leads use -

Pheonix Contact p/n AI 1-RD/32 00 03 0 or

American Electrical/DigiKey 1181010/288-1015-ND

Tighten screws to 5 in-lb.

EP204-I00-0000

9606XX-XX A1

SN 0610E014

Front View

24 Vdc

MOTOR