Installation manual

60
Safety Information Product Overview Installation Diagnostics
Options and
Accessories
Specification
STI-24IO
The STI-24IO interface board allows access to all digital input and output signals. The STI-24IO mounts directly to
the digital I/O connector (J3) on the front of the EP drive. See figure 63 below.
Shield connection points are connected to the shell of the 26 pin “D” connector on the STI-24IO.
The STI-24IO wire range is #18 to 24 AWG stranded insulated wire.
Wiring should be done with consideration for future troubleshooting and repair. All wiring should be either color
coded and/or tagged with industrial wire tabs. Low voltage wiring should be routed away from high voltage wiring.
Figure 63: Dimensions of the STI-24IO Board
Do not allow ESD directly to terminals. Always discharge static electricity to enclosure, not the drive when
performing maintenance.
+24V
0V
0
1
2
3
4
5
6
7
TB1
TB2
TB4
TB3
OUTPUTS
1
2
3
4
5
6
7
8
INPUTS
EN
8
9
10
11
12
13
14
15
3.2
2.1