Instruction manual

Instruction Manual Supplement

D103560X012

DVC6200p Digital Valve Controller

November 2014

Setting PG/PC Interface

Note

Setting the PG/PC interface or PC card (CP 5711 or similar PROFIBUS card) is done only once, after the first hardware installation of

the PC card inside the computer.

1. Set PG/PC Interface is available under the PC ‘Control Panel’ once Siemens STEP 7 or SIMATIC Manager/PDM

software is installed.

a. Go to Set PG/PC Interface as shown in figure 2.

b. Under the Interface, click on Select... to add the PCI/PCMCIA/USB type PROFIBUS card installed on the PC.

c. Once the interface or card appears as shown in figure 2, select the interface adapter installed and click on

Properties. In this example, the PC Adapter USB A2.PROFIBUS.1 <Active> is selected.

For further support on Setting PG/PC Interface visit the following Siemens website for detailed setup procedures:

http://support.automation.siemens.com/WW/view/en/25471997

Figure 2. Set PG/PC Interface

SELECT THE

PROFIBUS

INTERFACE

ADAPTER