Instruction manual

Instruction Manual Supplement
D103560X012
DVC6200p Digital Valve Controller
November 2014
7
5. Confirm the status is OK (see figure 6.) If the status is Failed, changes to the parameters set in step 2 may be
required.
Note
If the“Test” fails, check the DP/PA coupler type used and the parameter setting, as recommended by the coupler manufacturer.
6. To identify the address of the host and any connected device select Read as shown in figure 6.
Figure 6. Status/Network Diagnostics
TEST STATUS
READ
7. Any master or slave (devices) that is connected will be reflected (in the example shown in figure 7, the PROFIBUS
card is connected to address 4). Station Active refers to Masters on the bus. Station Passive refers to the slave
(devices) on the bus. An active ready PLC (Master Class 1) will be denoted as Station Active Ready.