Instruction manual

Instruction Manual Supplement
D103560X012
DVC6200p Digital Valve Controller
November 2014
8
Figure 7. Status/Network Diagnostics—Station Address
STATION ADDRESS
BUS NODE 55
Note
The default address of the DVC6200p is set by the factory to 126.
Note
In the above example, a slave device was found at Bus Node 55, and the Class 2 Master device is at address 4.
Make note of the addresses found during the bus node scan for future reference.
Note
It is not necessary to make any changes to information found in the other tabs.
8. Select OK to close the Set PG/PC interface.
Loading the DVC6200p EDD to the SIMATIC Manager/PDM Catalog
Open the Device Integration Manager - Siemens.
Load the EDD file from a source directory or from a compressed source, as shown in figure 8. Navigate to the EDD file,
highlight and select Open to add the EDD to the catalog (see figure 9).