Installation Instructions

Instruction Manual
D100325X012
1061 H & J Actuator
October 2012
19
a. Position the travel indicator (key 38) accordingly. Replace the cover (key 34), and secure it with the cap screws
and washers (keys 35 and 76). If the holes in the cover and housing (key 21) do not align, use a regulated air
source to move the actuator slightly off the up travel stop. If hole alignment cannot be obtained in this manner,
temporarily loosen the cap screws (key 24), and shift the housing slightly. Do not stroke the actuator while the
cover is off. Then, tighten both sets of cap screws to the torque values listed in table 7.
b. If a manual handwheel actuator is used, refer to the separate instruction manual for mounting instructions.
10. Follow the instructions in the Adjustment section for turnbuckle adjustment.
Parts Ordering
When corresponding with your Emerson Process Management sales office about this equipment, refer to the serial
number found on the actuator nameplate (key 42, figure 6). Also, specify the complete 11-character part number
from the following parts list when o rdering replacement parts.
WARNING
Use only genuine Fisher replacement parts. Components that are not supplied by Emerson Process Management should
not, under any circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the
performance of the valve, and could cause personal injury and property damage.
Repair Kits
Key Description Part Number
Kits include keys 5, 8, 16, 17, 18, and 56.
Size 30 R1061X00302
Size 40 R1061X00402
Size 60 R1061X00602
Size 68 R1061X00682
Parts List
Note
Part numbers are shown for recommended spares only. For part
numbers not shown, contact your Emerson Process Management sales
office.
Key Description Part Number
Actuator
1 Cylinder Assembly, aluminum/stainless steel
2 Cylinder Flange, aluminum
3 Cap Screw, pl steel
Key Description Part Number
4 Cylinder Cap, aluminum (for sizes 30, 40, & 68 only)
5*
(1)
O-Ring, nitrile (for sizes 30, 40, & 68 only) 10A3800X012
6 Cap Screw, pl steel (2 req'd) (for sizes 30, 40, & 68 only)
7 Piston, aluminum
8*
(1)
O-Ring, nitrile
Size 30 1H862106992
Size 40 1H862206992
Size 60 1H862406992
Size 68 1H862506992
9 Cap Screw, pl steel
9 Hex Nut, pl steel
Size 68 only
10 Piston Rod, pl S41600 (416 SST), heat treated
11 Hex Nut, pl steel
12 Rod End Bearing, pl steel/stainless steel
13 Cap Screw, pl steel
14 Hex Nut, pl steel
15 Travel Stop, steel (for 60-degree rotation only)
16*
(1)
O-Ring, nitrile
Size 30 1H862006992
Size 40 1D444806992
Size 60 1H862306992
Size 68 1H862506992
17*
(1)
O-Ring, nitrile
Size 30 1B8855X0042
Sizes 40 & 60 1H8498X0022
Size 68 1D3483X0012
18*
(1)
O-Ring, nitrile
Size 30 12A9480X012
Sizes 40 & 60 1V3234X0012
Size 68 13A0824X012
19 Sliding Seal, alum/PTFE anodize
*Recommended spare parts
1. Included in repair kit.