Instruction Manual

Instruction Manual
D200160X012
4195K Controllers
December 2012
123
Regulator Mounting Parts
Description
Regulator Mounting Parts for
Casing‐Mounted Regulator
Cap screw, hex hd, pl steel
(2 req'd)
Lock washer, pl steel (2 req'd)
Cap screw, hex hd, pl steel (2 req'd)
Hex nut, pl steel (2 req'd)
Mounting bracket, G10100 (pl steel)
For 657/667 size 80 & 100
For all other types
Regulator Mounting Parts for Yoke‐Mounted
Regulator (Mounting Bracket Not Required)
Cap screw, hex hd, pl steel (2 req'd)
Lock washer, pl steel (2 req'd)
Regulator Mounting Parts for Yoke‐Mounted
Regulator (With Mounting Bracket)
Cap screw, hex hd, pl steel
(2 req'd)
Lock washer, pl steel (4 req'd)
Cap screw, hex hd, pl steel
(2 req'd)
Hex nut, pl steel (2 req'd)
Mounting bracket, G10100 (pl steel)
For 1061, size 30, all shaft sizes
For all other types
Fittings
Description
Note
The quantity shown make up the fitting for one end of the tubing or
hose. Specify quantity of fittings required.
Fittings for 3/8‐inch tubing, casing‐ or
yoke‐mounted controller with regulator
Connector, brass (2 req'd)
Elbow, brass (2 req'd)
Fittings for 3/8‐inch tubing,
pipestand‐mounted controller with regulator
Elbow, brass (2 req'd)
Fittings for 3/8‐inch tubing,
all controllers without regulator
Connector, brass (1 req'd)
Elbow, brass (1 req'd)
Fittings for 1/2‐inch synthetic rubber hose,
all controllers w/ or w/o regulator
Connector, 316 SST
Elbow, 316 SST
Swivel, 316 SST (2 req'd)