Data Sheet

D4 Valve
D103039X012
Product Bulletin
51.2:D4
November 2013
2
Features (continued)
Electric and Pneumatic
 NACE Constructions–NACE compatible trim is
available with the D4 control v alve. These
constructions meet the metallurgical requirements
of NACE MR0175 / ISO 15156.
 Quick-Change Valve Plug–Removable groove pin
allows quick, easy valve plug replacement.
 Severe Service Capability with Tungsten Carbide
Trim–D4 valves are available with tungsten carbide
trim for erosive service. This trim is designed
specifically for severe service applications in the oil
and gas industry. Durable tungsten carbide trim
may benefit your application by wearing better and
lasting longer.
 Easy Installation–Compact design allows
installation where space is a premium. Screwed
valve bodies feature compact face-to-face
dimensions while flanged valve bodies conform to
ISA-75 standards for maximum versatility.
 Easy Maintenance–Hammer nut bonnet/body joint
allows repair or maintenance with a minimum of
tools, without removing the valve body from the
piping system. Seat ring can be removed with the
same service tools used with a Fisher D valve.
 Integral Bonnet Flange– Bonnet has an integral
flange that accepts hammer nut force when making
the bonnet-to-body connection. There are no snap
rings subject to possible failure in sour service o r in
atmospheric corrosion.
 Standard Trim for Throttling or On-Off Service–
Micro-Form trim is standard for throttling or on-off
service at no extra cost.
 Application Flexibility–Choices of port diameters up
to 31.8 mm (1.25 inches), end connections, and
trim materials suit these valves to many
applications, including sour service.
Electric
 Low Power Consumption-- The Fisher easy-Drive
electric actuator operates with 12 or 24VDC and
less than 0.1 watt hours per operation, using
Modbus,4-20mA,1-5VDC,ordrycontactcontrol
signals.
 Low Temperature-- Theeasy-Driveelectricactuator
design allows use in ambient temperatures as low
as -20C(-4F) without use of a heater.
 Easy Installation--The compact design allows
installation where space is a premium. Fisher
easy-Drive calibrates by simply opening and closing
the valve.
 Remote Monitoring and Configuration-- Loss of
signal position is programmable over Modbus.
Pneumatic
 Low Temperature Materials--Valve c onstruction
materialsallowuseinapplicationsaslowas-40C
(-40F) for the pneumatic actuator.
Installation
D4 control valves may be installed in any position, but
normally the actuator is vertical and above the valve.
Install the control valve so the flow direction arrow on
thesideofthevalvebodyindicatesthedirectionofthe
process flow.
Dimensions are shown in tables 12 and 13 and
figures 1 and 2.