Instruction Manual

ManualsBrandsEmerson ManualsValve InstrumentationEmerson Fisher FIELDVUEDVC6200 SIS Digital Valve Controller

www.Fisher.com

Fisherr FIELDVUE™ DVC6200 SIS Functionality

with User-Provided Pushbutton

The FIELDVUE DVC6200 SIS digital valve controller can be used with a userprovided pushbutton for the purpose of

initiating or cancelling a partial stroke test and for manual reset purposes. The pushbutton will connect to the Auxiliary

Terminals.

The procedures contained in this Instruction Manual Supplement are to be considered as a guideline only and should

be modified to address site‐specific requirements. Use these procedures in conjunction with the Safety manual

(D103601X012) and Instruction Manual (D103557X012). In addition, exercise good engineering practices and abide

by specific plant safety guidelines for safe operation.

WARNING

This instruction manual supplement is not intended to be used as a stand-alone document. It must be used in conjunction

with the following documents:

Safety manual for DVC6200 SIS Digital Valve Controller (D103601X012)

Fisher FIELDVUE DVC6200 SIS Instruction Manual (D103557X012)

Failure to use this instruction manual supplement in conjunction with the above referenced manuals could result in

personal injury or property damage. If you have any questions regarding these instructions or need assistance in obtaining

either of these documents, contact your Emerson Process Management sale office.

Instruction Manual Supplement

D103798X012

DVC6200 SIS

November 2013

Summary of content (4 pages)

PAGE 1
Instruction Manual Supplement DVC6200 SIS D103798X012 November 2013 Fisherr FIELDVUE™ DVC6200 SIS Functionality with User-Provided Pushbutton The FIELDVUE DVC6200 SIS digital valve controller can be used with a userprovided pushbutton for the purpose of initiating or cancelling a partial stroke test and for manual reset purposes. The pushbutton will connect to the Auxiliary Terminals.
PAGE 2
DVC6200 SIS Instruction Manual Supplement November 2013 D103798X012 Configuring Push Button Partial Stroke Test using ValveLink™ Software After the successful completion of Setup Wizard select Instrument Setup > Detailed Setup and find the Initial Setup tab. Find the Aux Terminal Mode parameter and set it to Push Button Partial Stroke Test. Running a Partial Stroke Test via Pushbutton Press the pushbutton for more than 3 seconds but less than 10 seconds to short the auxiliary terminals.
PAGE 3
Instruction Manual Supplement DVC6200 SIS D103798X012 November 2013 Enabling Manual Reset Capability using ValveLink Software Select Instrument Setup > Detailed Setup and find the SIS/Partial Stroke tab. Under SIS Options, find the parameter DVC Power Up and select Manual Reset.
PAGE 4
DVC6200 SIS Instruction Manual Supplement November 2013 D103798X012 Manually Resetting a Valve Locked in Safety Position via Pushbutton If the DVC6200 SIS experiences a loss of power or responds to a safety demand from the logic solver, Manual Reset locks the device in its safety position until the digital valve controller is reset. You can determine whether Manual Reset has locked the device in the safety position by monitoring the Locked In Safety Position alert in the status monitor.