Instruction Manual

Basis Weight Actuator

Figure 12. Limit Switch Connection Schematic, 4 Limit Switches (Optional)

E0017 / IL

INSTALLED AT

FACTORY IN

DIN RAIL

(O.D. = 10.7mm)

over-tightened, the switch action may

not allow the switch to close after it has

been tripped.

5. Use the handwheel to position the actuator to 90

degrees rotation (fully open).

6. Repeat steps 3 and 4 for the limit switch for 90 de-

grees rotation (LS1).

7. Replace the travel indicator cover and screws.

Stroking Speed

Stroking speed adjustments for the manual (MAN) and

automatic (COMP) modes are on the faceplate of the

IC500 card (key 3, figure 4). If it appears that motor

torque is too low, decrease stroking speed.

Note

In this manual, the default half-step in-

crement is referred to as a step.

The two trim potentiometers (screwdriver adjustments)

on the front panel of the IC2000 are for setting each of

the selectable preset speeds. The slowest speed is

approx. 600 steps/second in Manual mode and

approx. 5 steps/second in Computer mode; this speed

is governed by trim potentiometer resistance. The

Fastest speed is about 20 seconds for full stroke in