Instruction Manual

Basis Weight Actuator

Figure 15. Control Connection Schematic without Remote Station and without Manual Station

WITH THIS CONNECTION TO COMPUTER THE ACTUATOR

CAN ONLY RUN WITH SLOW SPEED.

CR1=INCREASE

CR2=DECREASE

NOTE:

IF THE MANUAL STATION IS INSTALLED, CONTROL CONFLICTS MAY OCCUR, SEE WIRING SECTION.

E0021 / IL

5. Check the meter again at 0 degrees rotation to be

sure zero has not changed.

Maintenance

WARNING

Avoid personal injury from sudden re-

lease of process pressure. Before per-

forming any maintenance operations:

D Shut off any line providing, electri-

cal power or a control signal to the ac-

tuator and Stepmotor Interface. Be sure

the actuator cannot suddenly open the

valve.

D Use bypass valves or completely

shut off the process to isolate the valve

from process pressure. Relieve process

pressure on both sides of the valve.

Drain the process media from both sides

of the valve.

D Keep power off when working in the

Stepmotor Interface.

A brief troubleshooting guide is provided below. Fol-

lowing the troubleshooting guide are maintenance pro-

cedures that can be completed in the field. For other

maintenance, return the actuator to Fisher Controls.

Due to the care Fisher Controls takes in meeting all

manufacturing requirements (heat treating, dimension-

al tolerances, etc.), use only replacement parts sup-

plied by Fisher Controls.