Installation manual

55
Setting Up Parameters
The maximum number of select lines is eight.
Once you have determined how many select lines you want, the assignments to these
Selector.Select lines must then be made in the Assignments view.
Figure 39: Assignment View
For example, if we entered 2 for the number of Input Destinations, we would have 4 selection
lines (Selector.Selection0 through Selector.Selection3). The Selector.Selection number that
is activated is determined by the status of the Selector.Select lines when the Selector.Selector
Initiate bit is activated. Each select line has a specific binary value.
The binary value is determined as follows:
S
n
x 2
n
where S
n
= Status of Selector.Select line n
Sn = 0 if Selector.Select line n is inactive, and
Sn = 1 if Selector.Select line n is active
The sum of all the binary values determines which Selector.Selection line will be active.
The following examples demonstrate how to determine which Selector.Selection will activate
based on the Selector.Select lines.
Example 1: