Owner`s manual

O If the SET indicator light blinks, turn the
cruise control main switch off and have
the system checked by an INFINITI
dealer.
O The SET indicator light may blink when
the cruise control main switch is turned
on while pushing the
RESUME/ACCELERATE, SET/COAST, or
CANCEL switch. To properly set the
cruise control system, perform the pre-
ceding steps in the order indicated.
1. RESUME/ACCELERATE switch
2. SET/COAST switch
3. CANCEL switch
4. MAIN (ONzOFF) switch
CRUISE CONTROL OPERATIONS
The cruise control allows driving at a speed
between 25 to 89 MPH (40 to 144 km/h)
without keeping your foot on the accel-
erator pedal.
To turn on the cruise control, push the
main switch on. The CRUISE indicator light
on the meter panel will come on.
To set at cruising speed, accelerate your
vehicle to the desired speed, push the
SET/COAST switch and release it. (The SET
indicator light will come on.) Take your foot
off the accelerator pedal. Your vehicle will
maintain the set speed.
O To pass another vehicle, depress the
accelerator pedal. When you release
the pedal, the vehicle will return to the
previously set speed.
O The vehicle may not maintain the set
speed when going up or down steep
hills. If this happens, drive without the
cruise control.
To cancel the preset speed, follow either of
these three methods:
a) Push the cancel switch. The SET indi-
cator light will go out.
b) Tap the brake pedal. The SET indicator
light will go out.
c) Turn the main switch off. Both the
CRUISE indicator and SET indicator
lights will go out.
O If you depress the brake pedal while
pushing the RESUME/ACCELERATE set
switch and reset at the cruising speed,
turn the main switch off once and then
turn it on again.
SSD0528
Starting and driving 5-23
Z 05.11.1/S50-D/V5.0 X