Owner`s manual

WARNING
Always follow the instructions below. Failure
to do so could result in damage to the charg-
ing system and cause personal injury.
1. If the booster battery is in another ve-
hicle
j
A
, position the two vehicles ( j
A
and the jumped vehicle: j
B
) to bring
their batteries into close proximity to
each other.
Do not allow the two vehicles to touch.
2. Apply parking brake. Move the selector
lever to the P (Park) position. Switch off
all unnecessary electrical systems
(light, heater, air conditioner, etc.).
3. Remove vent caps on the battery (if so
equipped). Cover the battery with an
old cloth
j
C
to reduce explosion
hazard.
4. Connect jumper cables in the sequence
as illustrated (
j
1
→
j
2
→
j
3
→
j
4
).
CAUTION
O Always connect positive (+) to positive
(+) and negative (−) to body ground (for
example, strut mounting bolt, etc. — not
to the battery).
O Make sure the jumper cables do not
touch moving parts in the engine com-
partment and that the cable clamps do
not contact any other metal.
5. Start the engine of the booster vehicle
j
A
and let it run for a few minutes.
6. Keep the engine speed of the booster
vehicle
j
A
at about 2,000 rpm, and
start the jumped vehicle
j
B
in the
normal manner.
CAUTION
Do not keep the starter motor engaged for
more than 10 seconds. If the engine does
not start right away, turn the key off and wait
3 to 4 seconds before trying again.
SCE0450A
VQ35DE engine
In case of emergency 6-11
Z 05.11.1/S50-D/V5.0 X