Owner`s manual

If the system does not operate as de-
scribed above, have it checked by an
INFINITI dealer.
INFINITI VEHICLE IMMOBILIZER
SYSTEM
The INFINITI Vehicle Immobilizer System
will not allow the engine to start without
the use of the registered key.
If the engine fails to start using the regis-
tered key (for example, when interference
is caused by another registered key, an au-
tomated toll road device or automated pay-
ment device on the key ring), restart the en-
gine using the following procedures:
1. Leave the ignition switch in the ON po-
sition for approximately 5 seconds.
2. Turn the ignition switch to the OFF or
LOCK position and wait approximately
10 seconds.
3. Repeat step 1 and 2.
4. Restart the engine while holding the de-
vice (which may have caused the inter-
ference) separate from the registered
key.
If this procedure allows the engine to
start, INFINITI recommends placing
the registered key on a separate key
ring to avoid interference from other de-
vices.
Statement related to section 15 of FCC
rules for INFINITI Vehicle Immobilizer
System (CONT ASSY-BCM, ANT ASSY-
IMMOBILISER)
This device complies with part 15 of the
FCC Rules and RSS-210 of Industry
Canada. Operation is subject to the follow-
ing two conditions;
(1) This device may not cause harmful in-
terference, and (2) this device must accept
any interference received, including inter-
ference that may cause undesired opera-
tion of the device.
CHANGES OR MODIFICATIONS NOT EX-
PRESSLY APPROVED BY THE PARTY RE-
SPONSIBLE FOR COMPLIANCE COULD
VOID THE USER’S AUTHORITY TO OPERATE
THE EQUIPMENT.
Security indicator light
The security indicator light j
A
blinks when-
ever the ignition key is removed for 5 sec-
onds after the ignition switch is in the OFF
position (mechanical key) or the ignition
switch is in the LOCK position (Intelligent
Key). This function indicates the security
systems equipped on the vehicle are op-
erational.
If a non-registered key is in the ignition
switch, the indicator light comes on.
SIC2153
2-20 Instruments and controls
Z 05.11.1/S50-D/V5.0 X