User guide

Installation

11 Liebert

GXT4

™

2.0 INSTALLATION

2.1 Unpacking and Inspection

Unpack the UPS and conduct the following checks:

• Inspect the UPS for shipping damage. If any shipping damage is found, report it to the carrier and

your local dealer or your Emerson representative immediately.

• Check the accessories included in packaging list. If there is any discrepancy, contact your local

dealer or your Emerson representative immediately.

2.2 What’s Included

• Terminal Block Communication Terminals

• Compact Disk with:

• Liebert MultiLink

Shutdown Software

• Configuration Program

• User Manual

• USB Cable—one, 1.2m (3.9 ft.) long

• RS-232 Cable—one, 2m (6-1/2 ft) long

• Cable Strain Relief—two pieces

• Rack mounting hardware, including screws, handles and mounting rail kit (not included with

model numbers ending with an “E”)

• Plastic tower stand sets—two (four pieces)

• Warnings, Safety Instructions booklet and WEEE recycling sheet (ISO 14001 compliance))

2.3 Preparation for Installation

2.3.1 Installation Environment

• Install the UPS indoors in a controlled environment, where it cannot be accidentally turned Off.

The installation environment should meet the specifications listed in 9.0 - Specifications).

• Place it in an area of unrestricted airflow around the unit, away from water, flammable liquids,

gases, corrosives, and conductive contaminants. Avoid direct sunlight.

Installation Clearances

Maintain at least 4 inches (100mm) clearance in the front and rear of the Liebert GXT4. Do not

obstruct the air inlets on the front panel and rear panel of the UPS; blocking the air inlets reduces

ventilation and heat dissipation, shortening the service life of the Liebert GXT4.

NOTE

The GXT4 External Battery Cabinet shipping package includes one battery cabinet, two spacers

for tower configuration and one DC power cable and rack mounting hardware, including

screws, handles and mounting rail kit (not included with model numbers ending with an “E”).

NOTE

Operating the Liebert GXT4 in temperatures above 77°F (25°C) reduces battery life.