User`s guide

Security
8 - 3
3. Select and configure these settings:
4. Select and configure these settings:
Setting Description
Require Login for System
Access
Specifies whether the system automatically prompts
users to log in when the system comes out of sleep
mode. Enabling this setting requires a login to use
the system.
User ID Specifies the ID for the user account.
User Password Specifies the password for the user account. To
enter numbers, use the number buttons on the
remote or keypad. To enter letters, press
Keyboard on the remote or keypad.
Setting Description
Enable Remote
Access
Specifies whether to allow remote access to the system by:
• Web
• Telnet
• SNMP
You may select any of these, or any combination of them.
Note: The system restarts if you change the remote access
settings. This setting does not deactivate the associated
port, only the application. Use Web Access Port to disable
the port.
AES Encryption Specifies how to encrypt calls with other sites that support
AES encryption.
• Off—AES Encryption is disabled.
• When Available—AES Encryption is used with any
endpoint that supports it, even if the other endpoints in
the call don’t support it.
• Required for Video Calls Only—AES Encryption is used
for all video endpoints in the call. Analog phone and
voice over ISDN connections are allowed. Video
endpoints must support AES Encryption to participate in
the call.
• Required for All Calls—AES Encryption is used for all
video endpoints in the call. Analog phone and voice over
ISDN connections are not allowed. All endpoints must
support AES Encryption to participate in the call.
Allow Video
Display on Web
Specifies whether to allow viewing of the room where the
system is located, or video of calls in which the system
participates, using the Polycom HDX web interface.
Note: This feature activates both near site and far site video
displays in Web Director.