User`s guide

Administrator’s Guide for Polycom HDX Systems
2 - 4
3. Select and configure these settings:
Default Gateway
(IPv6)
Displays the gateway currently assigned to the system.
If the system does not automatically obtain a gateway IP
address, enter one here.
Changing this setting causes the system to restart.
Setting Description
Setting Description
Host Name Indicates the system’s DNS name.
Changing this setting causes the system to restart.
Domain
Name
Displays the domain name currently assigned to the system.
If the system does not automatically obtain a domain name, enter
one here.
DNS Servers Displays the DNS servers currently assigned to the system.
If the system does not automatically obtain a DNS server address,
enter up to four DNS servers here.
• IPv6: You can specify IPv6 DNS server addresses for IP
addresses entered manually or obtained automatically (in the
case of a system on a hybrid network that obtains IPv4 DNS
server addresses via DHCPv4).
• IPv4: You can specify IPv4 DNS server addresses only when
the IPv4 address is entered manually. When the IPv4 address
is obtained automatically, the DNS Server addresses are also
obtained automatically.
Changing this setting causes the system to restart.
LAN Speed Specify the LAN speed to use. Note that the speed you choose
must be supported by the switch.
Choose Auto to have the network switch negotiate the speed
automatically. Choosing Auto automatically sets Duplex Mode to
Auto. If you choose 10 Mbps, 100 Mbps, or 1000 Mbps you must
set Duplex Mode to Half or Full.
Note: Polycom does not support Auto for the Polycom HDX
system only or the switch only; the settings for both must be the
same.
Changing this setting causes the system to restart.