User`s guide

ManualsBrandsEmerson ManualsCD PlayerHD8000

Monitors and Cameras

3 - 19

5. Select and configure these settings for Polycom HDX 9000 series,

Polycom HDX 8000 series, and Polycom HDX 7000 series systems:

Setting Description

Camera 4

(Camera 3 on

Polycom HDX 7000

series)

Specifies the computer or other video source’s aspect ratio:

•4:3 — Select if you are using a computer with a standard

display.

• 16:9 — Select if you are using a computer with a

wide-screen display.

Specifies the content format (Polycom HDX 9000 series):

•VGA — Select if the computer or video source is

connected to the Polycom HDX system using a VGA

cable.

•DVI — Select if the computer or video source is

connected to the Polycom HDX system using a DVI

cable.

Name Specifies a name and icon for the computer or video source.

Source Specifies whether the video source is People or Content.

Video sources specified as Content are sent at a higher

resolution and lower frame rate.

Note: If you change this setting on a Polycom HDX 7000

series system, the Source for Camera 2 is automatically

changed to match this setting.

Video Quality Specifies Motion or Sharpness for the video input.

•Motion — This setting is for showing people or other

video with motion.

• Sharpness — The picture will be sharp and clear, but

moderate to heavy motion at low call rates can cause

some frames to be dropped. Sharpness is available in

point-to-point H.263 and H.264 calls only.

Detect Camera Detects any supported PTZ camera connected to Polycom

HDX system video input 4 (input 3 on Polycom HDX 7000

series), and configures the camera settings accordingly.

This button appears only when RS-232 Mode is set to

Camera PTZ and Camera Control is set to Camera 4

(Camera 3 on Polycom HDX 7000 series) for one of the

serial ports.

Horizontal

Position, Phase,

Vertical Position

Polycom HDX 9004

Polycom HDX 9002

Polycom HDX 9001

Adjusts the VGA Input settings.

1. Select Horizontal Position, Phase, or Vertical

Position.

2. Press the navigation buttons on the remote control to

adjust the setting.

3. Press Back on the remote control to accept the

setting.