user manual

7
Operating Humidifier Controls
The operating controls of your Emerson
evaporative humidifier are located on the top
center of the humidifier. The controls are
found under the smoked cover, located
between the air circulating fans. Lift the con-
trol cover by placing your finger in the round
cutout and lifting. The cover will stay open.
Now you can clearly see the control area.
Familiarize yourself with the controls and ref-
erence the diagram of the control area for
the correct naming used within this manual.
To Operate the Controls
Humidity Control:
Adjust the amount of humidity depending on
your needs. The humidifier will turn on and off
as required to maintain level of humidity
selected. A medium setting (half way
between and is recommended, but
there are times when a low or high amount of
humidity may be preferred. For constant
operation of humidifier, turning the control all
the way clockwise allows for the maximum
amount of humidity to be evaporated into the
air continuously.
IMPORTANT: Water damage may result if
condensation starts to form on windows or
walls. Humidity Control setting should be
lowered until condensation no longer forms.
Green Humidity Light
When the selected humidity level is met, the
fans will shut off and the green “Desired
Humidity” light will illuminate. When more
humidity is called for, the fans will turn on and
the light will go out.
Air Flow Control
The unit is adjusted from OFF “ ” to high
“ ” with a three speed rotary control.
The higher the air flow speed, the more water
is evaporated and released into the air. Low
speed “ ” is the quietest and is provided for
conditions that may not require as high an
evaporation rate.
Fill Light
When the unit has a small amount of water
left in it, the amber fill light will come on
and the unit will automatically shut off.
NOTE: This humidifier is designed so the
right bottle as viewed from front empties first.
For maximum run time between fills, let both
bottles empty completely before refilling.
Manual Dryout
At the end of the humidification season or if
you do not plan to run the humidifier for one
week or more, you can override the auto-
matic shutoff function to completely dry the
humidifier cabinet out.
To do this, simply slide the float retainer locat-
ed at the back of the humidifier cabinet to the
top position of the slot it is located in. This will
hold the float in an upward position and the
fans will run until you turn the power off.
NOTE: Be sure to position float retainer to
the normal operating mode (lowest position
in slot) for normal operation.
Below is a diagram of the slot the float retain-
er is located in at the back of the cabinet.
Back of Cabinet
TOP POSITION
IS FOR MANUAL
DRYOUT
BOTTOM POSITION
IS FOR NORMAL
OPERATION MODE
FLOAT
RETAINER
SLOT
SP6551 manual - 71238 7/12/05 1:56 PM Page 7