Operating instructions

ManualsBrandsEmerson ManualsHome building and Decorinsinkerator

Slotted Screwdriver, Adjustable Pliers, Plumber’s Putty,

Electrical Tape

Phillips Screwdriver, Drain Auger, 3/8" Electrical Clamp

Connector, Wire Nuts (2), Second 1 1/2" Drain Trap,

Hammer, Hacksaw, Water Hose Clamp, Pipe Wrench,

Copper Ground Wire, Dishwasher Drain Connection Kit, Air

Gap, Electrical On/Off Switch, Drain Tube Extension

Mounting Assembly

A: Stopper

B: Sink Flange

C: Fiber Gasket

D: Backup Ring

E: Mounting Ring

F: Screws (3)

G: Snap Ring

Disposer

H: Mounting Gasket/Splash Bafe

I: Lower Mounting Ring

J: Dishwasher Inlet

K: Discharge Outlet

L: Wrenchette

FOOD WASTE DISPOSER

Installation, Care & Use Manual

Read through the entire Installation, Care

& Use manual before installing the dis-

poser. Determine which of the tools,

materials, and accessories you will need

before you begin. Make sure you have all

necessary disposer parts before install-

ing the disposer (see part identication

diagram below).

TOOLS AND MATERIALS YOU WILL NEED:

TOOLS, MATERIALS, AND ACCESSORIES

YOU MAY NEED:

Part No. 73104A - 3/31/02

SAFETY SYMBOLS

Danger indicates an

imminently hazardous situation which,

if not avoided, will result in death or

serious injury.

DANGER

Warning indicates

a potentially hazardous situation

which, if not avoided, could result in

death or serious injury.

Caution indicates a

potentially hazardous situation which,

if not avoided, may result in minor or

moderate injury.

Two-Bolt Discharge

N: Bolt (2)

O: Discharge Tube (1-1/2" Diam.)

P: Flange

Q: Gasket

One-Bolt Discharge

N: Bolt

O: Discharge Tube (1-1/2" Diam.)

P: Flange

Q: Gasket

The Emerson logo is a trademark and a

service mark of Emerson Electric Co.

Summary of content (8 pages)

PAGE 1
FOOD WASTE DISPOSER The Emerson logo is a trademark and a service mark of Emerson Electric Co.
PAGE 2
INSTALLATION INSTRUCTIONS 1 CHECK INSTALLATION DIMENSIONS Model A: Disposer Height B: Distance from bottom of sink bowl to centerline of discharge outlet. (Add 1/2" when stainless steel sink is used.) C: Distance from centerline of the discharge outlet to end of discharge tube. D: Disposer Width E: Distance from disposer vertical centerline to centerline of P-trap connection. F: Centerline of disposer discharge to centerline at waste pipe entering wall.
PAGE 3
6 REMOVE EXISTING DISPOSER 1. Turn off electrical power at fuse box or circuit breaker. DANGER Electric Shock • Turn off electrical power at fuse • Disposer must be grounded. box or circuit breaker before Improper connection can removing electrical cover plate. result in electric shock. Personal Injury • Do not position your head or body under disposer; unit could fall during removal or installation. 2. Disconnect drain trap from disposer waste discharge tube with adjustable pliers (see Fig. 6-1).
PAGE 4
9 CONNECT DISPOSER TO ELECTRICAL SUPPLY DANGER Electric • Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded. Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. • This disposer must be properly grounded.
PAGE 5
10 CONNECT DISPOSER TO MOUNTING ASSEMBLY Clear any objects from inside the disposer grind chamber before mounting the disposer. Personal Injury: Do not position your head or body under disposer; unit could fall during installation. 1. Position disposer with three mounting tabs (A) aligned in position to slide over mounting tracks (B) (see Figure 10-1). 2.
PAGE 6
12 CONNECT DISHWASHER DRAIN (IF APPLICABLE) Connect the dishwasher to the disposer through an air gap (A). (Most dishwasher manufacturers recommend that the discharge water runs through an air gap to prevent backflow and/or dishwasher contamination.) Ensure knockout plug is removed (see Instruction 1). Plumbing connections must comply with local plumbing codes. • If you have a 7/8" diameter dishwasher drain hose, use a hose clamp to attach the drain hose to the dishwasher inlet.
PAGE 7
OPERATING INSTRUCTIONS CONTINUOUS FEED DISPOSERS 1. Remove stopper from sink opening and run strong flow of cold water. 2. Turn on wall switch to start disposer. 3. Slowly insert food waste into disposer and position stopper to minimize possible ejection of material while grinding (see Figure A). 4. After grinding is complete, turn disposer off and run water for at least 15 seconds to flush drain line.
PAGE 8
IN-SINK-ERATOR® DISPOSER IN-HOME FULL SERVICE WARRANTY 777SS - Seven Year Warranty 555SS - Five Year Warranty 444 - Four Year Warranty 17 - Five Year Warranty This warranty covers all replacement parts and repair labor to correct defects in disposer material and workmanship for the full warranty period from the date of installation in your home.