User manual

Equipment Inspection and Handling
37 Liebert
®
DS
™
5.0 EQUIPMENT INSPECTION AND HANDLING
Upon arrival of the unit and before unpacking it, verify that the labeled equipment matches the bill of
lading. Carefully inspect all items for damage, either visible or concealed. For initial access use a
7/32" Allen wrench for panel removal. Damage should be immediately reported to the carrier and a
damage claim filed with a copy sent to Emerson Network Power or to your sales representative.
5.1 Packaging Material
All material used to package this unit is recyclable. Please save for future use or
dispose of the material appropriately.
SAFETY INFORMATION
NOTICE
Risk of overhead interference. The unit may be too tall to fit through a doorway while on the
skid. Measure the unit and doorway heights and refer to the installation plans to verify
clearances prior to moving the unit. If the Liebert DS is too large to fit through doors, halls or
other tight spaces, the unit can be partly dismantled as detailed in 7.0 - Disassembling the
Liebert DS for Transport.
NOTICE
Risk of damage from forklift. Keep tines of the forklift level and at a height suitable to fit
below the skid and/or unit to prevent exterior and/or underside damage.
NOTICE
Risk of damage from forklift. Keep tines of the forklift level and at a height suitable to fit
below the skid and/or unit to prevent exterior and/or underside damage.
NOTICE
Risk of improper storage. Keep the Liebert DS upright, indoors and protected from dampness,
freezing temperatures and contact damage.
Figure 32 Equipment recommended for handling Liebert DS
!
WARNING
Risk of top-heavy unit falling over. Can cause equipment damage, injury or death.
Read all of the following instructions before attempting to move the unit, lift it, remove
packaging or prepare the unit for installation.
!
CAUTION
Risk of sharp edges, splinters and exposed fasteners. Can cause personal injury.
Only properly trained personnel wearing appropriate safety headgear, gloves, shoes and
glasses should attempt to move the unit, lift it, remove packaging or prepare the unit for
installation.
R
Spreader Bars and Slings
Piano Jacks
Pallet
Jack
Forklift