User manual

Disassembling the Liebert DS for Transport

Liebert

™

7.0 DISASSEMBLING THE LIEBERT DS FOR TRANSPORT

The Liebert DS has a modular frame construction that allows separating the unit into three sections.

Each of these sections is more easily maneuvered through tight spaces or placed in small elevators.

A qualified service technician with the required tools and recommended assistance can disassemble

an air-cooled unit in about four hours, assuming refrigerant evacuation is not required.

This procedure requires four or more people for lifting the filter and electric box assembly on

downflow units and for lifting the blower and electric box assembly on upflow units.

NOTICE

Risk of improper disassembly. Can cause equipment damage.

Disassembling this unit requires substantial work, including reclaiming refrigerant and

charging the unit, cutting and brazing refrigerant lines, cutting and brazing water lines,

disconnecting and reconnecting electrical lines and moving heavy, bulky equipment. One

member of the crew disassembling the unit must be qualified in wiring, brazing and

refrigeration.

Improperly disassembling or reassembling the Liebert DS may affect warranty.

7.1 Required Equipment

•Piano jacks

• Stepladder for downflow units

• Refrigeration tools

WARNING

Risk of explosive discharge from high-pressure refrigerant. Can cause injury or death.

This unit contains fluids and/or gases under high pressure. Relieve pressure before working

with piping, compressors or other internal components.

WARNING

Risk of top heavy unit falling over. Improper handling can cause equipment damage, injury,

or death.

Read all instructions before attempting to move or lift unit. Installation and service of this

equipment should be done only by properly trained and qualified personnel who have been

specially trained in the installation of air conditioning equipment.

CAUTION

Risk of sharp edges and heavy parts. Can cause personal injury.

Only properly trained and qualified personnel wearing appropriate safety headgear, gloves,

shoes and glasses should attempt to move, lift, remove packaging from or prepare unit for

installation.

CAUTION

Risk of handling heavy and lengthy parts. Can cause personal injury and equipment damage.

Cabinet panels can exceed 5ft. (1.5m) in length and weigh more than 35lb. (15.9kg). Follow

relevant OSHA lifting recommendations and consider using a two-person lift for safe and

comfortable removal and installation of cabinet panels. Only properly trained and qualified

personnel wearing appropriate safety headgear, gloves and shoes should attempt to remove or

install cabinet panels.